Advanced Elements STRAITEDGE AE1006 Owner's Gebruikershandleiding - Pagina 13
Blader online of download pdf Gebruikershandleiding voor {categorie_naam} Advanced Elements STRAITEDGE AE1006 Owner's. Advanced Elements STRAITEDGE AE1006 Owner's 20 pagina's. Inflatable kayak
Ook voor Advanced Elements STRAITEDGE AE1006 Owner's: Gebruikershandleiding (12 pagina's)
Pagina afdrukken
5. PROPER CARE AND STORAGE
use and care will increase the life of your kayak. Before storing your kayak, make sure it is both
CLEAN and DRY. You may clean your kayak with a mild soap and water. NEVER use strong
solvents to clean your kayak as they will destroy the material.
NEVER unzip the chamber cover when the kayak is inflated.
kept out of direct sunlight when stored. Avoid exposure to extreme temperatures (hot or cold).
If your boat is exposed to freezing temperatures while storing, allow it to warm up before
unfolding.
Do not store your kayak for an extended period of time while wet.
Follow these steps for removing excess water.
1. Unzip the 2 zippers that run down the sides of the kayak.
2. Use a sponge or towel and wipe up any excess water in the outer cover.
3.
4. If there is sand or gravel in the kayak, you can hose out the cover, and then wipe it
down with a towel.
5. Most of the time you can wipe out the inside of the kayak absorbing most of the water,
then pack it up.
6. REPAIRS
All kayaks come with a repair kit that includes a glueless peel-and-stick patch. For more significant
repairs, we include a selection of material patches that can be glued on. Simply aquire a PVC
glue at your local marine or outdoor store or contact our Customer Service for assistance via
email at [email protected] or 1-866-262-9076.
6.1 Repairing Small Punctures and Cuts Using the Peel-And-Stick Patch
1. Cut a patch to size (approx. 1/2" larger than the hole or damaged area).
2. Carefully clean the area where patch will be placed with water and/or mild soap.
3. Make sure all surfaces are completely dry befor proceeding.
4. Carefully peel back the paper liner on the glueless patch and carefully apply the patch
over the hole-taking care to avoid any bubbles in the patch. Rub all edges to seal.
5. As a rule of thumb, the patch will start to cure immediately with approx. immediate
adhesion of 50% with full 100% adhesion 24 hours after application.
6.2 Repairing Pinholes
1.
you see air bubbles. Mark the location of the pinhole.
2.
3. Allow glue to dry completely.
4.
13