DRAKE DAD860 Gebruiksaanwijzing - Pagina 7

Blader online of download pdf Gebruiksaanwijzing voor {categorie_naam} DRAKE DAD860. DRAKE DAD860 15 pagina's. Digital to analog decoder
Ook voor DRAKE DAD860: Gebruiksaanwijzing (15 pagina's)

Pagina afdrukken

DAD860 Controller Controls and Connections

FRONT PANEL INDICATORS & CONNECTIONS

DAD860 Controller

DRAKE

DAD860

UNIT

F1 - LCD DISPLAY - This displays the selected

DAD860 unit number, the selected parameter, and

its value.

F2 - UP Button - When in program mode, this

button scrolls upward through the available param-

eter values. When not in the program mode, this

button will have no effect.

F3 - LEFT Button - This button scrolls counterclock-

wise through the available parameters for the

selected unit.

F4 - UNIT Button - This button scrolls in numeric

order through the available DAD860 units. When a

unit is selected, its amber LINK LED will flash

continuously. While the LINK light is flashing, the

LCD will display the selected unit number and the

signal to noise ratio of the received signal or "NO

LOCK" if no signal is being received. After a unit is

selected, the controller backlight and the selected

unit's amber LINK light will extinguish after approxi-

mately 40 seconds if there are no other control

inputs.

F5 - ENTER Button- Pressing this button for two

seconds will enter the program mode for the se-

lected DAD860. This is indicated by the LCD

flashing on and off at an interval of approximately

one second. Once in the program mode, pressing

ENTER will store the value of the selected param-

eter and exit program mode.

ENTER

F6 - RIGHT Button - When in program mode,

pressing this button will save the selected param-

eter value and will then scroll clockwise to the next

parameter, while remaining in the program mode.

When not in program mode, it will scroll clockwise

through available parameters without saving any

data. When in program mode, it is also used to

access secondary menus, progress through sec-

ondary menu trees and to store the value selections

in these menus.

F7 - DOWN Button - When in program mode, this

button scrolls downward through the available

parameters. When not in the program mode, it will

have no effect.

REAR PANEL INDICATORS & CONNECTIONS

COMM

POWER

+5V

+12V

GND

R1 - COMM Connector - This connector provides a

means of connecting the controller to each of the

DAD860 units. A supplied cable is attached to this

connector the other end of which is terminated in

ten numbered three conductor connectors. The

connector number corresponds to the unit number

of the DAD860 to which it is connected.

R2 - POWER Connector - This three conductor

connector connects to one of the twelve cables from

the PSM121 power supply to supply power for the

programmer.