Bosch exxcel 7 1200 express Gebruiksaanwijzing - Pagina 2

Blader online of download pdf Gebruiksaanwijzing voor {categorie_naam} Bosch exxcel 7 1200 express. Bosch exxcel 7 1200 express 8 pagina's.

Bosch exxcel 7 1200 express Gebruiksaanwijzing
Safety instructions
Care
- Read and follow the operating and installation instructions and all other information enclosed
with the washing machine.
- Retain documents for subsequent use.
Risk of electric shock
- Never pull out the mains plug by tugging the power cord!
- Never insert/pull out the mains plug with damp hands.
Risk of injury
- Washing machine door may become very hot.
- Caution when draining hot detergent solution.
- Do not climb on the washing machine.
- Do not lean on the open washing machine door.
- Do not touch the drum in case it is still spinning.
1.
- Caution when opening the detergent drawer while washing
machine is running!
Risk of posioning
- Keep detergents and care products out of the reach of children.
2.
Risk of suffocation
- Keep packaging, plastic film and packaging parts out of the reach
of children.
3.
Danger to life
On redundant appliances:
- Pull out the mains plug.
4.
- Sever the power cord and discard together with the plug.
- Destroy the lock on the washing machine door. This will prevent
5.
children from locking themselves in and suffocating.
Risk of explosion
- Caused by detergents containing solvents, e.g. stain
remover/items of washing pretreated with solvent naphtha may
result in an explosion after being loaded into the washing machine.
Beforehand thoroughly rinse items of washing by hand.
Consumption values
Programme
Additonal
Load
Current
**
Water
**
Programme
function
duration
**
Cottons Æ 40 ºC*
Wash Plus
X
7 kg
0.65 kWh
60 l
2:30 h
Cottons Stains ã 60 ºC*
Wash Plus
X
7 kg
1.19 kWh
49 l
2:36 h
Cottons Æ 90 ºC
X
7 kg
2.00 kWh
75 l
2:33 h
Wash Plus
Easy-Care Ç 40 ºC*
X
Wash Plus
3 kg
0.55 kWh
50 l
1:24 h
Easy-Care Ç 40 ºC*
(also suitable as short
-
3 kg
0.54 kWh
40 l
0:55 h
Information on the display panel
programme)
Mixed Load åä 30 ºC
-
3 kg
0.32 kWh
35 l
0:44 h
Silk æ 30 ºC
-
2 kg
0.25 kWh
38 l
0:32 h
F:16
Wool u 30 ºC*
2 kg
0.15 kWh
34 l
0:40 h
F:17
* Programme setting to be tested in accordance with European standard 60 456.
F:18
Note on comparative tests: test the test programme with maximum load, Wash Plus
X
option
F:21
selected, maximum spin speed.
A short programme which can be used for coloured items is Easy-Care Ç 40 ºC, without the
F:23
Wash Plus
X
option selected and set to maximum spin speed.
** The values deviate from the indicated values depending on water pressure, water hardness, water
inlet temperature, room temperature, type and amount of washing and degree of soiling, utilised
detergent, fluctuations in the mains voltage and selected additional functions.
7
8
Risk of electric shock!
Maintenance
Pull out the mains plug!
Risk of explosion! No solvents!
Machine housing, control panel
Detergent solution pump
- Wipe with a soft, damp cloth.
Set programme selector to Off, pull out the mains plug.
- Do not use any abrasive cloths, sponges or cleaning agents (stainless steel cleaner).
1.
Open and remove service flap.
- Immediately remove washing and cleaning agent residue.
- Do not clean the appliance with a water jet.
Clean the detergent drawer ...
For models with drainage hose:
2.
Take drainage hose out of the holder and pull out of the
... if it contains detergent or fabric softener residue.
housing. Remove sealing cap, allow detergent solution
to flow out.
Pull out, depress insert, completely remove.
Press on sealing cap and insert drainage hose into the
holder.
For models without drainage hose:
Open the cover.
2* Carefully unscrew pump cover until the detergent solution begins to run out.
When the service flap is half full,
Clean with water and dry.
screw back the pump cover and empty the service flap.
Repeat steps until all the detergent solution has run out.
Close and lock the cover (place cylinder on guide pin).
3.
Carefully unscrew the pump cover (residual water).
Insert detergent drawer.
4.
Clean the interior, pump cover thread and pump housing (fan impeller in the
detergent solution pump must rotate).
5.
Reinsert and screw on pump cover.
Leave detergent drawer open so that residual water can evaporate.
6.
Insert and close service flap.
Drum
To prevent unused detergent from flowing into the outlet during the next wash:
Pour 1 litre of water into dispenser II and select the Drain b programme.
Leave washing machine door open so that the drum can dry out.
Rust stains use chlorine free cleaning agent, not steel wool.
Filters in the water supply
Descaling
No washing in the machine!
Risk of electric shock! Do not immerse Aqua Stop safety device in water
Descale according to the instructions of the descaling agent manufacturer, not required for
correct detergent dosage.
Release water pressure in the supply hose:
1.
Turn off the tap!
depending on model
2.
Select any programme (except Spin B/Drain b).
Press Start M. Leave programme for approx. 40 seconds.
3.
4.
Set programme selector to Off.
Close the washing machine door properly; washing may be caught.
5.
Remove hose from tap.
Turn the tap on fully, supply hose kinked/jammed;
6.
Clean filter with small brush.
clean filter -> page 10, water pressure too low.
7.
Depending on the model, remove hose from the rear
of the appliance and clean the filter.
Clean detergent solution pump -> page 10, outlet pipe/drainage hose blocked.
Motor fault. Call customer service!
8.
Connect the hose and check for leaks.
Water in the base pan, appliance leaking. Call customer service!
9
Risk of scalding!
What to do if ...
Allow detergent solution to cool down!
Turn off the tap!
F
Water is running out.
- Correctly attach/replace drainage hose.
- Tighten screw fitting on the supply hose.
F
Water not flowing in.
- Start M not selected?
Detergent not washed in.
- Tap not open?
- Filter blocked? Clean filter -> page 10.
- Supply hose kinked or jammed?
F
Washing machine door
- Safety function active. Wait approx. 2 minutes.
cannot be opened.
- L (Rinse hold = without final spin) selected?
F
Programme does not start.
- Start M selected?
- Door closed?
F
Detergent solution is not
- Clean detergent solution pump -> page 10.
drained.
- Clean outlet pipe and/or drainage hose.
F
Washing not spun correctly.
- Distribute small and large items of washing in the drum.
F
Spin cycle actuated several
- Not a fault - unbalanced load detection system adjusts
times.
imbalance.
F
Water not visible in the drum. - Not a fault - water below the visible area.
F
Residual water in the
- Not a fault effect of the care product not impaired.
dispenser for care product.
F
Odour formation in the
- Run Cottons Æ 90 ºC programme without washing.
washing machine.
Use standard detergent.
F
Foam is coming out of the
- Too much detergent used?
detergent drawer.
Mix 1 tablespoon of fabric conditioner with ½ litre of water
and pour into dispenser II in the detergent drawer.
- Reduce detergent dosage for the next wash cycle.
F
Vibrations during spin cycle.
- Appliance feet fixed?
Secure appliance feet -> Installation instructions.
- Transportation safety devices removed?
Remove transportation safety devices -> Installation
instructions.
(contains electric valve).
F
Spin result not satisfactory.
- Reduced Ironing
F
Display panel/indicator lights
- Power failure?
do not function while the
- Fuse tripped? Switch on/replace fuse.
appliance is running.
- If the fault occurs repeatedly, call customer service.
F
Programme progress longer
- Not a fault - unbalanced load detection system adjusts
imbalance by repeatedly distributing the washing.
than usual.
- Not a fault - Foam detection system active a rinse cycle is
started.
F
Detergent residue on the
- Occasionally phosphate free detergents contain
washing.
water insoluble residue.
- Select Rinse/Freshen Up á or brush the laundry after
washing.
F
If a fault cannot be rectified or a repair is required:
- Set programme selector to Off and pull out the mains plug.
- Turn off the tap and call customer service -> Installation instructions.
10
Washing machine
Operating instructions
e
selected? -> page 5.
Read these instructions before switching on the washing machine!
Also follow the separate Installation instructions.
Follow the safety instructions on page 8!
11
en