Draper Onyx Montage/assemblage-instructies
Blader online of download pdf Montage/assemblage-instructies voor {categorie_naam} Draper Onyx. Draper Onyx 2 pagina's. Permanently tensioned projection screen
Ook voor Draper Onyx: Montage/assemblage-instructies (2 pagina's), Montage/assemblage-instructies (2 pagina's)
Pagina afdrukken
Onyx Permanently Tensioned Projection Screen by Draper
1 Read instructions through completely before proceeding.
2 Follow instructions carefully. Installation contrary to instructions
invalidates warranty.
3 Screen should be accessible for complete removal should fabric
become damaged or should other service be required.
4 Screen should be installed level (using a carpenter's level).
5 Nothing should be fastened to screen frame or viewing surface.
6 Make sure you have received all parts (see parts list below and
exploded diagram on page 2).
7 Tools Required:
/
" Allen wrench (included); #2 Phillips screwdriver.
1
8
Optional tools: Flat blade screwdriver or small putty knife.
8 Installer is responsible for providing appropriate hardware for mounting.
9 When lifting assembled screen, do not lift at only one corner; lift at
both corners. Lifting by one corner could result in damage to the
screen frame, especially on large screens.
10 The ideal temperature range for assembling folding screens to prevent
damaging the surface is 68°-78° F (20°-26° C). Assembling below
recommended temperatures may damage surface and void warranty.
NOTE: Screen has been thoroughly inspected and tested at factory and
found to be operating properly prior to shipment.
Onyx—Hardware and Parts List
Frame Extrusions - 4
Surface Retention
Extrusions - 4
Wall-Brackets - 2
1
/
" Allen Wrench - 1
8
Frame Preparation
1 Clean area and place frame assembly pieces face down. Insert frame
extrusion connectors into aluminum frame extrusions as indicated in
Figures 1 through 4. For easier assembly insert the inner connectors first.
Figure 1
Please Note: If extrusion connectors do not slide into frame extrusions, make
sure that setscrews are backed out enough to allow proper clearance.
Patented by Draper, Inc., U.S. Patent Nos. 6,785,047; 7,113,332; and 7,369,310.
®
Copyright © 2013 Draper Inc.
Form Onyx_Inst13
Assembly/Mounting Instructions
Caution
Frame Extrusion
Connectors - 8
Plastic Tubing - 4
Viewing Surface - 1
Figure 2
Printed in U.S.A.
Figure 3
2 Make sure frame extrusion connectors are fully seated (see Fig. 5).
3 Secure connectors by tightening setscrews (see Fig. 6).
4 Repeat steps 1-3 for the remaining corners (see Fig. 7).
The Onyx has a precision cut mitered corner.
Please Note: If corner gaps exist (painted frame only) readjusting the frame
and/or applying a small bead of black silicone to fill the gap is the best solu-
tion. Apply a very small bead of black silicone to area where frame gap exists.
Work silicone into gap (using your finger or a cloth). Remove ALL silicone on
face of frame; only silicone inside gap should remain.
Caution: When lifting assembled screen, do not lift at only one corner; lift
at both corners. Lifting by one corner could result in damage to the screen
frame, especially on large screens.
If you encounter any difficulties installing or servicing your Onyx screen, call your
dealer or Draper, Inc., Spiceland, Indiana, (765) 987-7999 or fax (765) 987-7142.
Figure 4
Figure 5
Figure 6
Figure 7
(Continued on Page 2)