Bosch WAE20060UC/22 Installatie-instructies - Pagina 2
Blader online of download pdf Installatie-instructies voor {categorie_naam} Bosch WAE20060UC/22. Bosch WAE20060UC/22 5 pagina's.
Ook voor Bosch WAE20060UC/22: Handmatig (6 pagina's)
Pagina afdrukken
-Thewashing machine isheavy. TO AVOID R ISK O F INJURY liftwith caution.
-Erozen h oses c an tear/burst. Donotinstall thewashing machine outdoors orinanarea
exposedtofreezing conditions.
--These i nstallation
instructions
are intended foruse byqualified installers.
Inaddition tothese
instructions,
ifinstalling the washing machine:
!ntheUnited S tates comply with theNational Electric Code, ANSI/NFPA70
- latest
edition/State and municil_al
and/or local regulations.
!nCanada comply withthe Canadian Electric Code C 22.1 - latest edition!provincial
and
municipal and/or local regulations.
-If thewashing machine islocated inaroom which w ill b eexposed totemperatures
below
freezing, orifitislocated inacabin t hatisbeing s hut d own f orthewinter, any residual water
in the pump o rwater inlet h ose(s) must b edrained.
--Take care nottodamage thewashing machine.
Donothold ontoprotruding parts
(e,g. door) w hen l ifting.
--Inaddition tothe safety i nformation
listed h ere, thelocal water end electricity supplier may
have special requirements.
-If indoubt, have t hewashing machine connected
byanauthorized
technician.
- Thewasher must notbestacked ontopofthe dryer. Serious injury a nd damage may result.
- Risk ofpersonal injury o rdeath. DO NOT stack a dryer ontopofthewasher without the use
of one ofthe stacking kitaccessories
listed i nthe dryer manual.
- Stability isimportant toprevent washer from moving excessively
during u sage.
- The installation
area must b efirm and level.
- Soft f loors/floor coverings are notsuitable.
Power cord
Drainage
hose
F
_
,
_!_;!iiiiii
_
Water supply hoses for
hot water (red marking)
Water supply hoses for
cold water (blue
marking)
Covers
A
w
Wrench (according to model)
Elbow
used with drain hose
Depending
on the connection
- 1 hose clip Q 0.94" / 24mm - 1.57" / 40mm (commercially available) for connection of the
siphon -> page 4; Water connection.
Useful
tools
- Bubble level for levelling the water.
- Y-connector (can be optained from any hardware store) in case there is only a cold water
connection.
order no. WMZ 20450.
To protect the washer drum from shifting, do not remove transportation bolt assemblies prior
............................................................
to installing the washer on the pedestal.
I!
[]
[]
a = 39in. / 100cm (approx.)
d = 57in. / 145cm (al_prox.)
b = 45in. / 115cm (approx.)
e = 25in. / 65cm (approx.)
c = 33in. / 85cm (approx.)
f = 53in. / 135cm (approx.)
Available commercially or from customer service:
- Longer supply hose 86 1/2 inches (2.2m approx.).
g = min. 23in. / 60cm
h = max. 39in. / 100cm
II