Draper Targa XL 220V Gebruiksaanwijzing - Pagina 3

Blader online of download pdf Gebruiksaanwijzing voor {categorie_naam} Draper Targa XL 220V. Draper Targa XL 220V 7 pagina's. Electric projection screen

Pagina afdrukken

Premier XL

Electric Projection Screen

Section 2 - Hanging Screen

General:

1. Screen should be lifted into position only by end mounting brackets. Keep case level by lifting end plates

simultaneously to prevent surface damage. Never attempt to lift screen along its length.

3. When locating viewing surface and checking clearance for screen's operation, remember surface is

centered in case. Handle case carefully to protect its finish.

4. Regardless of mounting method, screen should be positively and securely supported so that vibration or

even abusive pulling on viewing surface will not cause case to work loose or fall. Installer must insure that

fasteners used are of adequate strength and suitable for mounting surface chosen.

Ceiling and Wall Installation:

CAUTION: Product is very heavy: Installer must provide adequate attachment hardware and

anchors as required. Installer must also insure that structure is of adequate strength.

CAUTION: Case must be mounted low enough from ceiling to gain access to bracket screws.

Please Note: Do not use a power screwdriver to tighten screw. Maximum torque for tightening

screw is 5 lb-inches.

Section 3 - Operation

Please Note: Before fully operating screen: For Targa, remove tape; on Premier, lower viewing surface enough to fully expose shipping brackets, then remove shipping

brackets by loosening screws, removing end shipping brackets, sliding center shipping brackets off dowel, and re-tightening screws

220V AC Single Station Control — 3-position up-off-down switch permits operation to be stopped at any point. Factory adjusted

limit switches automatically stop screen when fully down or fully up.

220V AC Multiple Station Control — Switches similar in appearance to 110-120V Single Station Control. Screen stops when switch

is released and may be restarted in either direction. Factory adjusted limit switches stop screen automatically when fully down

or fully up.

For LVC-IV Controls:

24V Control — Three-button up-stop-down

Factory adjusted limit switches automatically stop screen when fully down or fully up.

1. The key-operated power supply switch controls power to unit and switches.

When it is "off", switches will not operate. Key may be removed from switch

in either "on" or "off" position.

2. A three-position key switch permits screen to be operated directly by key.

In this case, screen operator must always have a key.

RS232 / Ethernet — Serial communication and network communication available.

Plug & Play

— Supplied with a 294.64cm cable lead. No wiring is necessary.

Screen is equipped with a handheld remote or 3-position operating switch.

Three positions

(up-off-down)

permit operation to be stopped at any point.

Factory adjusted limit switches automatically stop screen when fully down or fully up.

Section 4 - Tab Tension Adjustment Procedure

1 Determine which side requires adjustment.

2 Secure dowel with one hand.

3 Using Phillips-head screwdriver, depress spring-loaded adjustment screw and slowly

turn CLOCKWISE TO INCREASE tension, or COUNTER-CLOCKWISE TO RELEASE

tension. The screw adjusts in ¼ turn increments. Adjust only one increment

at a time.

4 If problem is not corrected, leave screen in position for 24 hours to allow surface

material to stretch into position.

5 If problem still is not corrected, repeat steps 2 and 3.

/ Targa XL

220V

switch(es)

stop at any point desired, operate in any sequence.

CAUTION: Do not touch or bend surface.

Figure 2

(¼ turn)

(Fig.

Figure 3

END OF

DOWEL

PUSH & TURN

COUNTER-CLOCKWISE

CLOCKWISE

to RELEASE TENSION

to INCREASE TENSION

page 3 of 7

3).

END OF

DOWEL