Draper GD16 Gebruiksaanwijzing - Pagina 6

Blader online of download pdf Gebruiksaanwijzing voor {categorie_naam} Draper GD16. Draper GD16 20 pagina's.

1. This drill press is intended for use

only with drill bits. The use of any

other accessories may be hazardous.

2. CHECK to see that the drill bit is

securely locked in the chuck.

3. CORRECT DRILLING SPEEDS

Important factors which determine the

best speed to use in any drill press

operation are:

(a) The smaller the drill the greater

the required r.p.m. (revolutions

per minute)

(b) In soft materials the speed should

be higher than for hard materials.

4. MAKE sure that the chuck key is

removed before turning on power.

ADDITIONAL SAFETY RULES FOR

DRILL PRESSES

5. CHECK to see that the chuck is

securely fastened to the spindle.

6. CAUTION

When practical, use a vice or clamps

to secure workpiece to avoid

workpiece rotating with the drill bit.

7. SECURE the tool to a workbench or

floor. If during operation there is any

tendency for the drill press to tip over,

slide or walk on the supporting

surface, the drill base must be secured

to the supporting surface with

fasteners through the holes located in

the drill press base.

8. For your safety DO NOT wear gloves

when operating a drill press.

- 5 -