Draper PT500V Gebruiksaanwijzing - Pagina 7
Blader online of download pdf Gebruiksaanwijzing voor {categorie_naam} Draper PT500V. Draper PT500V 12 pagina's.
Pagina afdrukkenIMPORTANT:
Make sure that the mains voltage matches the
voltage stated on the machines rating plate.
SWITCH:
The switch ✪✌ on both of these tools are fitted
with a locking device, ✫✌, allowing the tool to
be operated for long periods of time without
interruptions. Fig.2.
Before inserting the plug into the socket, check
that the switch is in the unlocked position. When
the tool is not is not to be used for long periods,
remember to leave the switch device in the
unlocked position.
SPEED REGULATOR:
An electronic speed regulation system has been
fitted. Speed regulation is by means of the switch
✪✌ push button. By increasing the pressure on
the switch, the rotation speed of the drill
gradually increases until the desired speed is
reached.
The maximum speed is set by means of the
graduated knurled knob ✬✌ (±), located on the
switch ✪✌. Fig.2.
PERCUSSION DRILLING SYSTEM:
These drills can pass from normal drilling to
percussion drilling, simply by switching the knob
fitted on top of the drill. It is possible to turn the
percussion system on and off, even whilst the
machine is running and without the risk of
causing damage to the mechanism.
Drilling position: Slide the knob towards the
drill bit symbol
Percussion drilling position: Slide the knob
towards the hammer symbol
CHANGING THE DIRECTION OF ROTATION:
These models are equipped with a reverse
selector ✮✌ in order to be able to rotate the
machine chuck either to the right or to the left.
Fig.2.
This operation should be performed when the
machine is stopped.
Because of this feature, the drill can also be used
as a screwdriver.
OPERATION & USE
.
.
✬✌
✮✌
✪✌
SUPPLEMENTARY HANDGRIP
For reasons of safety, when working with this type
of electric power tool, the operator should always
use the adjustable handgrip.
In order to fit the handgrip to the drill, loosen the
wing nut on the side of the handgrip, turning in
an anticlockwise direction.
Slide the handgrip onto the drill collar, tilting it to
the desired angle; then tighten until it is securely
attached to the machine.
To fit the depth stop, loosen the wing nut on top
of the handgrip, turing in an anticlockwise
direction. Insert the depth stop into the
adjustable handgrip collar, and position for the
correct depth, then tighten until it is secure.
IMPROPER USE
The functions and use of these tools are those
exclusively indicated in this manual.
- 6 -
✫✌
Fig.2.