Draper BS190 Gebruiksaanwijzing - Pagina 12

Blader online of download pdf Gebruiksaanwijzing voor {categorie_naam} Draper BS190. Draper BS190 20 pagina's. Two wheel bandsaw
Ook voor Draper BS190: Gebruiksaanwijzing (20 pagina's)

Pagina afdrukken

TOOLS REQUIRED FOR ASSEMBLY

Your new bandsaw can be assembled and adjusted using a few hand tools including:

Engineers/Combination Square,

No.2 Cross Slot Screwdriver,

Medium Plain Slot Screwdriver,

ASSEMBLY

INSTALLING THE TABLE:

1. Remove the bolt, washer and wing nut from the

table slot. Place the table ✪✌ Fig.14. onto the

bandsaw frame and making sure the blade

travels through the slot in the table.

2. Fasten the table to the frame using the tilting

lock knobs ✭✌ Fig.15.

3. Place the table insert ✮✌ on the table as shown

in Fig.16. and assemble the table alignment bolt

✯✌ washer and wing nut ✰✌ to the table. The

washer and wing nut should be positioned below

the table.

FASTENING TO WORK BENCH

(fixings not supplied)

Your bandsaw should be bolted to a solidly built

work bench. Mounting holes are provided in the

base of the machine. Large flat washers should be

used between the bolt heads and the base to fasten

more securely and to prevent any damage to the

bandsaw. Tighten snugly but do not overtighten.

ADJUSTING THE UPPER BLADE GUIDE

ASSEMBLY

The upper blade guide assembly ✱✌ Fig.17. should

always be set approximately 3mm (

close as possible to the upper surface of the

workpiece being cut.

⁄

") above or as

- 12 -

Fig.14.

✪✌

✭✌

Fig.15.

Fig.16.

✮✌

Fig.17.

✱✌

✯✌

✰✌