Draper CS14A Gebruiksaanwijzing - Pagina 9

Blader online of download pdf Gebruiksaanwijzing voor {categorie_naam} Draper CS14A. Draper CS14A 16 pagina's. 350mm chop saw
Ook voor Draper CS14A: Gebruiksaanwijzing (12 pagina's)

Pagina afdrukken

ASSEMBLY

1. This cut-off saw is shipped with the cutting head

locked in the down position as shown in Fig.3.

2. Pull locking pin ✪✌ Fig.3. to enable the cutting

head to be in the up position as shown in Fig.3.

3. Lock the spindle shaft by depressing shaft locking

button ✭✌ see Fig. 6.

Using the hex key provided (inserted in the base),

loosen the wheel flange securing bolt ✫✌.

Remove the outer flange ✬✌ and install the

cutting disc on the arbor shaft. Fig.4.

4. Fit the outer flange ✬✌ then tighten by hand the

hex bolt ✫✌ Fig.5.

5. Lock the spindle shaft by depressing shaft locking

button ✭✌ see Fig.6.

Make sure the spindle shaft is secured by turning

the cutting wheel by hand. Then, using the hex

wrench, tighten hex bolt ✫✌. Fig.5.

NOTE: Do not overtighten as this may cause

damage to the cutting disc.

Fig.3.

✪✌

Fig.4.

✬✌

✫✌

- 7 -

✫✌

✭✌

Fig 5.

Fig.6.