Draper FlexShade Slim NEXD Installatie- en bedieningsinstructies - Pagina 3
Blader online of download pdf Installatie- en bedieningsinstructies voor {categorie_naam} Draper FlexShade Slim NEXD. Draper FlexShade Slim NEXD 7 pagina's.
Pagina afdrukken
Clutch-Operated FlexShade
Slim Hardware
PLEASE READ - Important Installation Information
Caution:
1. Inspect all boxes to make sure you have
received the proper shades and parts.
Controls may be shipped separately, or in
same carton as shades.
2. Open cartons lengthwise, taking care not
to cut into cardboard shipping container.
Section 1 - FlexShade NEXD Mounting With Endcap
Caution: Before mounting shades, verify measurements on label provided with shade, and ensure unit is installed at correct width.
Please Note: Installer is responsible for selecting mounting hardware appropriate for site conditions.
Figure 1
Ceiling Mounting with Endcap
1. Mark ceiling for placement of
endcaps.
2. Drill small starter hole
(if necessary)
in mounting surface.
3. Attach endcap covers to endcaps.
4. Mount endcaps using appropriate
fasteners for surface.
Figure 2
Wall Mounting with Endcap
(See Section 2 to convert between
ceiling and wall mounting configurations
as needed.)
1. Mark wall for placement
of endcaps.
2. Drill small starter hole
(if necessary)
in mounting surface.
3. Attach endcap covers to endcaps.
4. Mount endcaps using appropriate
fasteners for surface.
Figure 3
Jamb Mounting with Endcap
1. Mark jamb for placement of
endcaps.
2. Drill small starter hole
(if necessary)
in mounting surface.
3. Attach idler and operator endcap
covers to endcaps.
4. Mount endcaps using appropriate
fasteners for surface.
Please Note: Requires a minimum of
2 fasteners. It is not necessary to
utilize all 4 corners.
NEXD,
®
3. Before mounting shades, verify measurements
on label provided with shade, and ensure unit
is installed at correct width.
4. All endcaps, fascia, pocket headbox, and
other hardware must be installed level.
Shades must be level and square.
1.
Push endcap
covers onto
both endcaps.
1.
Push endcap
covers onto
both endcaps.
1.
Push endcap
covers onto
1.
both endcaps.
6. Read the following installation guidelines
7. Installer is responsible for selecting mounting
2.
Mount
endcaps
to ceiling.
2.
Mount
endcaps
to wall.
1.
2.
2.
Mount
endcaps
to jamb.
page 3 of 7
thoroughly and follow them carefully.
Failure to do so may cause product to fall or
otherwise fail, and invalidates warranty.
hardware appropriate for site conditions.
Section 2 - Converting
Between Ceiling and Wall
Mounting Configurations
1. Remove these three screws from
endcaps.
(Fig. 4 for steps 1-3)
2. Rotate metal mounting plate 90° toward
the mounting surface.
3. Reattach these three screws to endcaps.
1.
Ceiling Mount
Configuration
2.
3.
Wall Mount
Configuration
.
Figure 4
2.
3.