Draper Futureguard FlexShade Zip Handleiding voor installatie-instructies - Pagina 3
Blader online of download pdf Handleiding voor installatie-instructies voor {categorie_naam} Draper Futureguard FlexShade Zip. Draper Futureguard FlexShade Zip 7 pagina's.
Pagina afdrukken
Futureguard® FlexShade Zip™
Installing Curved, Square or Angled Headbox Zip 92 and Zip 127 Screens
If installing Zip 127 Angled Headbox supported by Side Channels, go to that section on page 5.
A — MOUNTING HEADBOX
Attaching Mounting Brackets
1 Attach Mounting Brackets to the wall using
flat head screws installed flush with the
bracket. Be sure to use AT LEAST 2 of the top
mounting holes (See Fig. 4).
2 Place the Headbox onto the brackets and
tighten Set Screws (See Fig 5).
3 You are now ready to mount the Side Channels (See Side Channel Mounting section on page 4).
B — MOUNTING HEADBOX
1 Attaching Mounting Brackets to Headbox
Attach Mounting
Figure 6
brackets to the
Headbox as a
spacer between
the Headbox and
the wall. Leave a
1¾" (45mm) gap
between End Cap
Leave a
and Mounting
1¾" (45mm)
Bracket (See Fig. 6),
GAP for
and tighten set
Side-Channels
screws.
2 Removing Roller Assembly (See Fig. 7)
A. Remove screws
from bottom of
Headbox, remove
Fascia and set
aside.
B. Remove Quick
Release Pin from
Idler End of Roller
Assembly.
C. Remove Roller
Assembly —
including motor —
Idler End first, and
set aside.
by Draper
With Mounting Brackets or directly to wall
WITH WALL BRACKETS
Figure 4
PERMANENTLY TO CEILING OR WALL WITH SCREWS
Mounting Bracket
as spacer and
Tighten Set Screws
REMOVE
FASCIA
REMOVE QUICK
REMOVE ROLLER ASSEMBLY
RELEASE PIN
Remove screws from
bottom of Headbox
Figure 7
Figure 5
3 Mounting to Celing/Wall
Using the mounting
holes in the End Caps as
a guide (See Fig. 8), drill
pilot holes on both ends
of the Headbox. Attach
to mounting surface
using appropriate
fasteners.
Attach
PLEASE NOTE: It is
the responsibility of
the installer to use
appropriate fasteners for
the mounting surface.
ALSO NOTE: If there is no cable exit provided, you must drill one
before re-installing Roller Assembly.
See Cable Exit section on page 2
4 Once the Headbox is secured to the mounting surface, re-install
Roller Assembly*, Quick Release Pin and Fascia.
5 You are now ready to mount the Side Channels (See Side Channel
Mounting section on page 4).
Tighten Set Screws
CEILING
CEILING
MOUNT HOLES
MOUNT HOLES
WALL
MOUNT HOLES
Figure 8
page 3