Draper 16061 Instructies voor - Pagina 11

Blader online of download pdf Instructies voor voor {categorie_naam} Draper 16061. Draper 16061 16 pagina's. 400w 230v oscillating multi-tool kit
Ook voor Draper 16061: Gebruiksaanwijzing (20 pagina's)

Pagina afdrukken

OPERATING THE POLISHER

9.1

OPERATING THE POLISHER

SWITCH - FIG. 5

To start the polisher, pull the trigger

hold. For prolonged operation, it is possible to

lock the trigger in the ON position. Pull trigger

and hold to start the polisher and push

button

. Release trigger

release button

the ON position. To release the lock, pull

trigger

and release.

9.2

STEPPED SPEED SETTING -

FIG. 6

Set the stepped speed in accordance to the

cutting paste/compound or polish being used.

Read the manufacturers instructions regarding

this. No responsibility or liability is accepted by

Draper Tools regarding the setting of the

correct speed for the job to be done. The

speed settings are approximately as per table

below.

Speed setting

NOTE: We strongly recommend that the

polisher, speed setting, the polishing

sponge/mop and medium being used are

tested on a small, inobscure area before

applying to a vehicle panel or similar.

IMPORTANT: Excessive pressure on the

machine does not result in higher working

speed. It increases wear on the internal

mechanics and can damage the polisher.

and then

.This will lock the trigger in

Corresponding RPM

(approx.)

600

1100

1600

2100

2600

3300

FIG. 5

and

FIG. 6