Bosch wlx24164gb Gebruiksaanwijzing - Pagina 2

Blader online of download pdf Gebruiksaanwijzing voor {categorie_naam} Bosch wlx24164gb. Bosch wlx24164gb 8 pagina's.

Pagina afdrukken
Safety instructions
Care
- Read and follow the operating and installation instructions and all other information enclosed
with the washing machine.
- Retain documents for subsequent use.
Risk of electric shock
- Never pull out the mains plug by tugging the power cord!
- Never insert/pull out the mains plug with damp hands.
Danger to life
Redundant appliances:
- Pull out the mains plug.
- Sever the power cord and discard together with the plug.
- Destroy the lock on the washing machine door.
This will prevent children from locking themselves in and
suffocating.
Risk of suffocation
- Keep packaging, plastic film and packaging parts out of the reach
1.
of children.
Risk of poisioning
- Keep detergents and care products out of the reach of children.
Risk of explosion
- Caused by detergents containing solvents, e.g. stain
2.
remover/items of washing pretreated with solvent naphtha may
result in an explosion after being loaded into the washing machine.
3.
Before hand thoroughly rinse items of washing by hand.
Risk of injury
- Washing machine door may become very hot.
4.
- Caution when draining hot detergent solution.
- Do not climb on the washing machine.
5.
- Do not lean on the open washing machine door.
- Do not touch the drum in case it is still spinning.
- Caution when opening the detergent drawer while washing
machine is running!
Consumption values
Programme
Additonal
Load
Current
**
Water
**
Programme
function
duration
**
Æ Cottons 40 ºC*
Wash Plus X
4,5 kg
0.55 kWh
50 l
2:11 h
Ã
Stains 60 ºC*
Wash Plus X
4,5 kg
0.76 kWh
40 l
2:15 h
Æ Cottons 90 ºC
Wash Plus X
4,5 kg
1.40 kWh
59 l
2:11 h
A Easy Care 40 ºC*
Wash Plus X
2,5 kg
0.45 kWh
50 l
1:31 h
A Easy Care 40 ºC*
(also suitable as short
-
2,5 kg
0.45 kWh
40 l
0:55 h
programme)
Information about the indicator lights
à Mixed Load 30 ºC
-
2,0 kg
0.60 kWh
30 l
0:44 h
Delicates 30 ºC
-
2,0 kg
0.20 kWh
36 l
0:32 h
depending on model
u Woollens 30 ºC*
-
2,0 kg
0.13 kWh
30 l
0:40 h
* Programme setting to be tested in accordance with European standard 60 456.
Note on comparative tests: test the test programme with maximum load, Wash Plus X additional
function selected, maximum spin speed.
A short programme which can be used for coloured items is A Easy Care 40 ºC, without the
Wash Plus X additional function selected and set to maximum spin speed.
** The values deviate from the indicated values depending on water pressure, water hardness, water
inlet temperature, room temperature, type and amount of washing and degree of soiling, utilised
detergent, fluctuations in the mains voltage and selected additional functions.
7
8
Risk of electric shock!
Maintenance
Pull out the mains plug!
Risk of explosion! No solvents!
Machine housing, control panel
Detergent solution pump
- Wipe with a soft, damp cloth.
Set programme selector to Off, pull out the mains plug.
- Do not use any abrasive cloths, sponges or cleaning agents (stainless steel cleaner).
1.
Open and remove service flap.
- Immediately remove washing and cleaning agent residue.
- Do not clean the appliance with a water jet.
Clean the detergent drawer ...
2.
Carefully unscrew pump cover until the detergent
solution begins to run out. When the service flap is half
... if it contains detergent or fabric softener residue.
full, screw back the pump cover and empty the service
flap. Repeat steps until all the detergent solution has run
Pull out, depress insert, completely remove.
out.
3.
Carefully unscrew the pump cover (residual water).
Open the cover.
4.
Clean the interior, pump cover thread and pump housing (fan impeller in the
Clean with water and dry.
detergent solution pump must rotate).
Close and lock the cover (place cylinder on guide pin).
5.
Reinsert and screw on pump cover.
Insert detergent drawer.
6.
Insert and close service flap.
To prevent unused detergent from flowing into the outlet during the next wash:
Pour 1 litre of water into dispenser II and select the Drain b programme.
Leave detergent drawer open so that residual water can evaporate.
Drainage hose at the siphon
Set the programme selector to Off, disconnect the mains plug.
Drum
1.
Loosen the hose clamp, carefully remove the drainage hose (residual water).
Leave washing machine door open so that the drum can dry out.
2.
Clean the drainage hose and siphon connecting piece.
Rust stains use chlorine free cleaning agent, not steel wool.
3.
Reattach the drainage hose and secure the connection with the hose clamp.
Descaling
Filters in the water supply
No washing in the machine!
Descale according to the instructions of the descaling agent manufacturer, not required for
Risk of electric shock! Do not immerse Aqua Stop safety device in water
correct detergent dosage.
Release water pressure in the supply hose:
1.
Turn off the tap!
2.
Select any programme (except Spin B/Drain b).
Select Start M. Leave programme for approx. 40 seconds.
3.
4.
Set programme selector to Off. Pull out the mains plug.
A signal sounds and indicator lights for the spin speed flash:
Clean filter:
Clean the detergent solution
Water in the base pan, appliance
Close the
1.
Depending on model:
washing machine
pump -> Page 10. Drainage
leaking. Call customer service!
- Remove hose from tap.
hose / waste pipe blocked;
> Installation instructions, Page 7.
door properly;
Clean filter with small brush.
Clean the drainage hose at
washing may be
or
caught.
the siphon -> Page 10.
- Remove hose from the rear.
Turn the tap on fully,
Remove filter with pliers and clean.
Motor fault!
supply hose kinked/jammed;
Call customer service!
clean filter -> Page 10;
2.
Connect the hose and check for leaks.
> Installation instructions, Page 7.
water pressure too low.
Release water pressure in the supply hose:
9
Risk of scalding!
What to do if ...
Allow deterhgent solution to cool down!
Turn off the tap!
F
Water is running out.
- Correctly attach/replace drainage hose.
- Tighten screw fitting on the supply hose.
- Start M not selected?
F
Water not flowing in.
Detergent not washed
- Tap not open?
in.
- Filter blocked? Clean filter -> Page 10.
- Supply hose kinked or jammed?
F
Washing machine door
- Safety function active. Wait approx. 2 minutes.
cannot be opened.
- Rinse Hold (Rinse stop = without final spin) selected? -> Page 4.
F
Programme does not
- Start M selected?
start.
- Washing machine door closed?
F
Detergent solution is not
- Clean detergent solution pump -> Page 10.
drained.
- Clean outlet pipe and/or drainage hose.
F
Water not visible in the
- Not a fault - water below the visible area.
drum.
F
Spin result not
- Wash small and large items of washing together.
satisfactory.
- Reduced Ironing e selected? -> Page 5.
- Too low speed selected? -> Page 3.
F
Spin cycle actuated
- Not a fault - unbalanced load detection system adjusts
several times.
imbalance.
F
Dispenser
2
not
- Clean detergent drawer and insert > Page 9.
completely rinsed out.
F
Odour formation in the
- Run Æ Cottons 90 ºC programme without washing.
washing machine.
Use standard detergent.
F
Foam is coming out of
- Too much detergent used?
the detergent drawer.
Mix 1 tablespoon of fabric conditioner with ½ litre of water and
pour into dispenser II in the detergent drawer.
- Reduce detergent dosage for the next wash cycle.
F
Intense noise formation,
- Appliance feet fixed?
vibrations and
Secure appliance feet > Installation instructions, Page 5.
"wandering" during spin
- Transportation safety devices removed?
cycle.
Remove transportation protection devices
> Installation instructions, Page 4.
F
Indicator lights do not
- Power failure?
(contains electric valve).
function while the
- Fuse tripped? Switch on/replace fuse.
appliance is running.
- If the fault occurs repeatedly, call customer service.
F
Programme progress
- Not a fault - unbalanced load detection system adjusts imbalance
longer than usual.
by repeatedly distributing the washing.
- Not a fault foam detection system active - a rinse cycle is
started.
F
Detergent residue on the
- Occasionally phosphate free detergents contain water insoluble
washing.
residue.
- Select K Rinse or brush the laundry after washing.
F
If a fault cannot be rectified or a repair is required:
- Set programme selector to Off and pull out the mains plug.
- Turn off tap and call customer service > Installation instructions, Page 7.
10
10
Washing machine
en
Operating instructions
Read these instructions before switching on the washing machine!
Also follow the separate Installation instructions.
Follow the safety instructions on page 8!