Drawmer MXPRO-50 Gebruikershandleiding - Pagina 8

Blader online of download pdf Gebruikershandleiding voor {categorie_naam} Drawmer MXPRO-50. Drawmer MXPRO-50 13 pagina's. Dual de-esser

CONTROL DESCRIPTION AND OPERATION

Both channels of the MX50 are identical and may be used completely independently or

linked for stereo operation. In the linked mode, the left and right channel control settings

are averaged, though the channel bypass switches remain independent. In linked mode,

both de-essers of the two channels track together to avoid the inevitable image shifting

that would occur if the stereo signal were treated independently.

Frequency

De-Ess

GR Display

Air

This control determines the lower range of the frequency band

used to detect sibilance and should ideally be set as high as

possible while still allowing the de-esser to react to sibilant

program sounds. This will vary from voice to voice, but will usually

be around 3 to 4kHz.

The control is continuously variable from 800Hz to 8kHz and

covers the full sibilant range, including the hard sounding

harmonics or other side effects that can be generated when treble

frequencies are boosted or enhanced in some way in an attempt to

add more definition to low frequency.

This rotary adjusts the amount of gain reduction that will take place

when a sibilant sound has been detected, up to a maximum of

20dB, this can be seen on the G.R. meter. Using large amounts of

gain reduction may cause very obvious artifacts, especially on

broadband mixes, so de-ess individual tracks where possible, and

choose Split Band mode for the least obtrusive processing.

This control uses floating threshold circuitry which tracks the signal

level so that the same setting can be used for signal levels over a

40dB range.

Shows how much gain reduction is being applied. In Full Band

mode, the gain reduction is applied to the whole signal, while in

Split Band mode, only frequencies above the value set on the

Frequency control are attenuated.

The AIR switch allows frequencies above the sibilant band (above

12kHz) to remain unaffected by De-Essing, thus preserving upper

harmonics and greatly increasing the transparency of signals

undergoing de-essing. Normally we would recommend leaving this

switch depressed (In).

MX50 OPERATORS' MANUAL