Bosch 800 Series Gebruiks- en onderhoudshandleiding - Pagina 42

Blader online of download pdf Gebruiks- en onderhoudshandleiding voor {categorie_naam} Bosch 800 Series. Bosch 800 Series 49 pagina's. Built-in wall ovens
Ook voor Bosch 800 Series: Handleiding voor installatie-instructies (24 pagina's), Installatiehandleiding (40 pagina's), Gebruiks- en onderhoudshandleiding (12 pagina's), Installatiehandleiding (23 pagina's), Installatiehandleiding (28 pagina's), Installatiehandleiding (32 pagina's), Gebruiksaanwijzing (32 pagina's), Installatiehandleiding (32 pagina's), Snelstart- en veiligheidshandleiding (7 pagina's), Gebruiks- en onderhoudshandleiding (40 pagina's), Installatiehandleiding (40 pagina's), Installatiehandleiding (32 pagina's), Handleiding voor installatie-instructies (40 pagina's), Installatiehandleiding (48 pagina's), Gebruiks- en onderhoudshandleiding (33 pagina's), Snelstarthandleiding (7 pagina's), Snelstart- en veiligheidshandleiding (13 pagina's), Installatiehandleiding (32 pagina's), Servicehandleiding (36 pagina's), Handleiding voor installatie-instructies (29 pagina's), Gebruiks- en onderhoudshandleiding (24 pagina's), Gebruiks- en onderhoudshandleiding (40 pagina's), Handleiding voor installatie-instructies (28 pagina's)

Pagina afdrukken
Bosch 800 Series Gebruiks- en onderhoudshandleiding
Oven Troubleshooting
Use these suggestions before calling for service to avoid
service charges.
Oven Problem
The oven mode or temperature selected
or the numbers selected do not appear in
the display
Oven door is locked and will not release,
even after cooling
Oven is not heating
Oven is not cooking evenly
Baking results are not as expected
Food takes longer to cook than expected
Food is overcooked
Convection Bake Results are not as
Expected
Oven temperature is too hot or too cold
Oven light is not working properly
Oven light will not turn off
Cannot remove lens cover on light
Oven will not Self-Clean properly
Clock and timer are not working properly
Porcelain chips
"E" and a number appears in display and
control beeps
English 39
Review manual instructions when setting clock, timer, or Self-Clean.
Turn the oven off at the circuit breaker and wait 5 minutes. Turn breaker
back on. The oven should reset itself and will be operable.
Be sure oven temperature has been selected. Check regulator switch as it
may be off.
Adjust oven calibration if necessary (see "Change the Oven Temperature
Offset" in this manual). Refer to cooking charts for recommended rack
position.
Refer to cooking charts for recommended rack position. Check "Getting the
Most Out of Your Oven" on page 24 for tips and suggestions. Adjust oven
calibration if necessary (see "Change the Oven Temperature Offset" in this
manual).
The oven is carefully calibrated to provide accurate results. However, the
temperature can be offset if food is consistently too brown or too light. See
"Oven Temperature Offset" on page 19.
The oven is carefully calibrated to provide accurate results. However, the
temperature can be offset if food is consistently too brown or too light. See
"Oven Temperature Offset" on page 19.
If the Automatic Convection Conversion Feature is turned off, the
temperature must be manually reduced by 25° F. If the feature is active, the
temperature is automatically adjusted. See "Turn Automatic Convection
Conversion ON or OFF" for more information. Refer to cooking charts and
tips for rack positions, cooking times and pan selection. Adjust oven
calibration if necessary. See "Oven Temperature Offset" on page 19.
The oven thermostat needs adjustment. See "Oven Temperature
Offset" on page 19.
Replace or reinsert the light bulb if loose or defective. Touching the bulb
with fingers may cause the bulb to burn out.
Check for obstruction in oven door. Check to see if hinge is bent. When the
Sabbath feature is activated, the oven light will stay on or off (as selected
during set-up) during the entire Sabbath mode.
There may be soil build-up around the lens cover. Wipe lens cover area
with a clean dry towel prior to attempting to remove the lens cover.
Allow the oven to cool before running Self-Clean. Always wipe out loose
soils or heavy spillovers before running Self-Clean. If oven is badly soiled,
set oven for a four-hour Self-Clean. See Preparing the Oven to Self-Clean.
Make sure there is electrical power to oven. See Clock and Timer sections.
When oven racks are removed and replaced, always tilt racks upward and
do not force them to avoid chipping the porcelain.
This is a fault code. Press Off to clear the display and stop beeping. Reset
oven if necessary. If fault code remains and beep continues, record fault
code, cancel oven and call authorized service technician.
Possible Causes and
Suggested Solutions