Alemlube G10042 Technische handleiding eigenaar - Pagina 2

Blader online of download pdf Technische handleiding eigenaar voor {categorie_naam} Alemlube G10042. Alemlube G10042 6 pagina's. 14.4v cordless grease gun

Pagina afdrukken

OWNER'S TECHNICAL MANUAL

PERSONAL SAFETY

1. Stay alert. Watch what you are doing, and use common sense when operating a power tool. Do not use a power tool while tired

or under the influence of drugs, alcohol, or medication. A moment of inattention while operating power tools may result in serious

personal injury.

2. Dress properly. Do not wear loose clothing or jewelry. Contain long hair. Keep your hair, clothing, and gloves away from moving

parts. Loose clothes, jewelry, or long hair can be caught in moving parts.

3. Avoid accidental starting. Be sure the Switch is released before plugging in. Carrying power tools with your finger on the Trigger,

or plugging in power tools with the Trigger depressed, invites accidents.

4. Remove adjusting keys or wrenches before turning the power tool on. A wrench or a key that is left attached to a rotating part

of the power tools may result in personal injury.

5. Do not overreach. Keep proper footing and balance at all times. Proper Tooting and balance enables better control of the power

tool in unexpected situations.

6. Use safety equipment. Always wear approved safety glasses underneath a full face safety shield. Dust mask, non-skid safety

shoes, hard hat, or hearing protection must be used for appropriate conditions.

WARNING

Do not use battery charger in damp or wet locations. Do not use the Grease Gun or Charger if it has been dropped, damaged,

left outdoors, or immersed in liquid. To avoid electrical shock, do not handle the charger, its power cord plug, or the Grease Gun

with wet hands.

Grease Gun can develop high pressure – up to 8,000 PSI. Use safety glasses and gloves for protection during operation.

Keep hands clear of the exposed rubber portion of Hose.

Extreme pressure may cause Nozzle extension or Flex Hose to burst. Use only APPROVED hoses and follow whip hose

instructions and warnings.

SAVE THIS MANUAL

You will need this manual for the safety warnings and precautions, assembly, operating, maintenance and cleaning procedures.

CHARGER OPERATION

CHARGING THE BATTERY PACK GENERAL

For best performance on a new battery you must discharge it completely to get full use of the batteries life cycle. Using a battery

that has been charged before it is completely discharged will shorten the batteries total amount of charge it will take in future

charging. This applies to a new gun too. Be sure to discharge the new battery completely before charging.

All New guns come with 80% charge from the factory and no charging is needed until it is used and the battery is run down.

Before using Grease Gun for the fist time, if the battery pack is installed in the gun, remove it by depress the two battery release

buttons (one button on each side of battery pack) and pull battery pack out of gun.

As a battery pack approaches the discharged state, you will notice a sharp drop in tool performance. When the tool is unable

to perform the task at hand, it is time to recharge the battery pack. Recharging the battery pack before this condition is reached

will reduce the total work life of the pack. Discharging the pack beyond this point can damage the pack.

Start the charging process by plugging in the battery charger and inserting the battery into battery charger slot.

After termination of the charging (approx. 1-2h), pull charger out of socket and remove battery.

NOTE: Battery temperature will increase during and shortly after use. Batteries may not accept a full charge if they are charged

immediately after use. Allow the battery pack to cool to room temperature before charging for best results.

NSW/ACT

QLD/PNG

TEL: (02) 9677 1555

TEL: (07) 3204 9166

FAX: (02) 9675 1155

FAX: (07) 3204 1224

14.4V Cordless Grease Gun

VIC/TAS

TEL: (03) 8787 8288

FAX: (03) 8787 8266

Visit our website at

www.alemlube.com.au

SA/NT

TEL: (08) 9302 4199

TEL: (08) 8241 7111

FAX: (08) 9303 2095

FAX: (08) 8241 7011

www.alemlube.co.nz

G10042

TEL: (09) 447 1007

FAX: (09) 447 1008