Electrolux 300 Series Gebruiks- en onderhoudshandleiding - Pagina 22
Blader online of download pdf Gebruiks- en onderhoudshandleiding voor {categorie_naam} Electrolux 300 Series. Electrolux 300 Series 46 pagina's. Front load dryer
Ook voor Electrolux 300 Series: Gebruikershandleiding (11 pagina's), Gebruiks- en onderhoudshandleiding (39 pagina's), Handleiding voor installatie-instructies (50 pagina's), Gebruiks- en onderhoudshandleiding (28 pagina's)
Pagina afdrukken
Installation
22
Rubber Washer
Must be Present
and Undamaged
3. Turn on COLD supply and run water to
clear any contaminants in the line.
4. Inspect hose couplings for proper
placement of rubber washers. Use
hoses from ASSEMBLY HOSE KIT#
5304495002 (not included).
5. If your installation has room for the
COLD water supply to accept the
"Y" connector directly, thread the "Y"
connector to the COLD water supply
and snug it by hand; then tighten it
another 2/3 turn with pliers.
NOTE
If you were able to install the "Y"
connector directly to the COLD water
supply, please skip to step 8.
Cold Inlet Hose
to Washer
Rubber Washers
MUST BE PRESENT
Short Hose
"Y" Connector
Cold Water Supply
Hose to Washer
6. If there is not room to install the "Y"
connector directly, thread the short
extension hose on to the COLD water
supply and snug it by hand; then
tighten it another 2/3 turn with pliers.
7. Thread the "Y" connector to the short
extension hose and snug it by hand;
then tighten it another 2/3 turn with
pliers.
8. Connect the COLD inlet hose for the
washer to the "Y" connector and snug
it by hand; then tighten it another 2/3
turn with pliers.
9. Connect the straight end of the long
hose from the kit to the other outlet
on the "Y" connector and snug it by
hand. Connect the hose's 90° coupling
to the brass water inlet on the back of
the dryer and snug it by hand. Tighten
each connection of the dryer inlet hose
another 2/3 turn with pliers.
10. Turn on the water and check for leaks
at all connections.
Water Inlet
on Dryer