Bosch HBC34D554B Gebruiksaanwijzing - Pagina 18

Blader online of download pdf Gebruiksaanwijzing voor {categorie_naam} Bosch HBC34D554B. Bosch HBC34D554B 32 pagina's. Combination steam oven
Ook voor Bosch HBC34D554B: Handleiding voor installatie-instructies (16 pagina's), Gebruiksaanwijzing (32 pagina's)

Pagina afdrukken

Troubleshooting

Malfunctions often have simple explanations. Please read the

following instructions before calling the after-sales service.

Repairs may only be carried out by fully trained after-sales

service technicians. Incorrect repairs to your appliance may

present considerable risks for the user.

Problem

The appliance does not work

Appliance does not start. [

appears in the display.

The appliance cannot be started

The appliance is not in operation. A dura-

tion is shown in the display

Appliance does not start. An audible sig-

nal sounds

Turning the temperature selector cancels

the cooking operation

and

‹‹

light up in the display

"‰

is shown in the display

The

indicator appears even though the

water tank is full

The

indicator appears even though the

water tank is not yet empty, or the water

tank is empty but the

indicator does not

appear

The water tank empties for no discernible

reason. The evaporator dish is overflowing

The evaporator dish has boiled empty

even though the water tank is full.

The

indicator appears

There is a "pop" noise during cooking

When you cook with steam, a lot of steam

is created

When cooking with steam, a lot of steam is

created again

Steam escapes from the ventilation slots

during cooking

Possible cause

The plug is not plugged in.

Power cut

Fuse defective

Faulty operation

Cleaning aid or descaling was cancelled

]

min

‹‹

...‹

The appliance door is not fully closed

A control knob was unintentionally

pressed

The

button was not pressed after mak-

ing the setting

A temperature outside of the possible tem-

perature range has been set

A temperature outside of the possible tem-

perature range has been set

Power cut

The automatic safety switch-off is active

The water tank has not been inserted

properly

The detection system is not working

The water tank is dirty. The mobile water

level indicators are jammed

The water tank was not closed properly

The tank lid seal is dirty

The seal in the tank cover is defective

The water tank has not been inserted

properly

The feed line is blocked

The appliance has not been used for at

least 2 days and the water tank is full

Cold/warm effect with frozen food, caused

by the steam

The appliance is being automatically cali-

brated

The appliance is unable to calibrate itself

automatically if cooking times are too

short

ã=

Risk of electric shock!

Work on the appliance electronics may only be performed by

■

a specialist.

Always disconnect the appliance from the power supply

■

when work is carried out on the electronics. Switch off the

circuit breaker or remove the fuse from your household fuse

box.

Notes/remedy

Connect the appliance to the electricity

supply

Check whether other kitchen appliances

are working

Check in the fuse box to make sure that

the fuse for the appliance is OK

Switch off the fuse for the appliance in the

fuse box. Wait approximately 10 seconds

and then switch it back on

Turn the operating mode selector to

and rinse the appliance twice

(see section "Cancelling the cleaning aid"

or "Cancelling descaling")

Close the appliance door.

Press and hold the

Press the

cooking operation, or press and hold the

button to cancel the setting

Check the temperature ranges for the

operating modes

Check the temperature ranges for the

operating modes. Press the

Reset the clock time (see section: "Time-

setting options")

Press any button.

Slide in the water tank until it locks into

place.

Call the after-sales service

Shake and clean the water tank. If the

parts cannot be released, obtain a new

water tank from the after-sales service.

Close the lid until you feel it engage.

Clean the seal

Obtain a new water tank from the after-

sales service

Slide in the water tank until it locks into

place

Descale the appliance. Check whether the

water hardness range is set correctly

Empty and clean the water tank. Always

empty the water tank after cooking

This is normal

Reset the appliance to the factory settings

(see Basic settings section). Then start

Steam at 100 °C for 20 minutes

This is normal

button

button briefly to start the

button