BDS EKF 530 Originele gebruiksaanwijzing - Pagina 12

Blader online of download pdf Originele gebruiksaanwijzing voor {categorie_naam} BDS EKF 530. BDS EKF 530 20 pagina's. Ekf series 300; ekf series 500; ekf series 600

Pagina afdrukken

Using

Switching on the machine

To switch on the machine, press and

hold down the ON/OFF switch (9).

Switching off the machine

To switch off the machine, release the

ON/OFF switch (9).

NOTE

If the ON/OFF switch is locked at the

"ON" position by the locking mecha-

nism (8):

►

Press the ON/OFF switch again.

The locking mechanism is released

automatically.

Milling with the machine

For milling, proceed as follows:

Align the workpiece to be processed

horizontally and secure it.

ATTENTION

Potential damage to property if the

machine is improperly used!

Observe the following instructions to

avoid damage to property:

►

Lay the connecting cable so that

it cannot be caught by the running

machine.

Set the chamfer height, see section

"Setting the chamfer height".

Insert the plug into the mains socket.

Clasp the handles and put the ma-

chine upright with the supporting plate

onto the workpiece so that the milling

milling cutter does not move onto the

workpiece.

NOTE

►

With the EKF Series 500/600, it is

possible to use both side handles (11;

1x short/1x long) either left or right.

Switch on the machine, see section

"Switching on the machine".

Wait until the necessary speed has

been reached. This process takes

approx. 3 seconds.

EKF Series 300/500/600