Bosch 0 986 612 997 Gebruiksaanwijzing - Pagina 9

Blader online of download pdf Gebruiksaanwijzing voor {categorie_naam} Bosch 0 986 612 997. Bosch 0 986 612 997 44 pagina's.

2. Delivery specification

- Force transmitter, type LPX 100 with connector cable, test range 0...100 kN

- 4 off, cheese head screws with hexagon socket DIN 912 - M 6 x 12 - 8.8

for fastening force transmitter to force measurement device 0 986 612 878

- Manual indicator type MMV22

- Fastening bracket for manual indicator

- 2 off 9 V block storage batteries (NiCd 9 V / 150 mAh) for voltage supply

- Charger for 9 V block storage battery

- Operating instructions

- Plastic case

3. Available service parts

- Operating instructions

4. Operation with storage battery

The voltage supply is established using a 9 V block storage battery.

Do not apply an external voltage source!

Prior to the first start up, both storage batteries should be charged using the charger which

is included as part of the delivery specification.

Charging will take roughly 2...3 hours for a completely empty storage battery.

During the charging process the charger's LED will go on.

Once the storage battery is charged, the charger will switch to maintenance charge and

the LED on the charger starts to flash on and off. It is not possible to overcharge the

storage battery.

The capacity of a charged storage battery will suffice for 3 hours of operation.

If the storage battery level drops below a specific minimum value, the following is

displayed in the manual indicator " +1.::. ". In this case, replace the storage battery

immediately and charge it.

Used and faulty batteries should not be disposed off with domestic waste.

Ensure they are disposed off in an environmentally compatible manner.

5. Operation with power pack

As an option the voltage supply can also be provided by means of a power pack, which is

connected to the power pack plug socket on the manual indicator.

Where a power pack is used then the power pack characteristic values must be observed;

they are available in Section 9.3.

6. Calibration

As part of your quality management (see QA Manual) the defined

for calibration must be observed.

Recommendation:

0 986 629 323

Every 24 months