Bosch 1615 Gebruiksaanwijzing - Pagina 8

Blader online of download pdf Gebruiksaanwijzing voor {categorie_naam} Bosch 1615. Bosch 1615 33 pagina's. Plunge router

Pagina afdrukken

If a shorter stroke is desired, turn the upper stop

nut closest to the cast boss 14 on the motor

down to the desired position, and lock in place

by firmly tightening the other upper stop nut

against it. If a fixed depth setting is desired, (no

plunge action) tighten a stop nut on either side

of the boss and the depth of cut will be rigidly

set.

Direction of Feed

The router rotates in a clockwise direction as

viewed from the top. The correct relationship

between direction of bit or cutter rotation and

router feed is shown below. It is very important

to move the router in the proper direction or bit

chatter and rough cutting will be the result.

As an example, to rout a decorative edge on the

front of a table top, you would move the router

from left to right to perform the operation, or

counter-clockwise around the workpiece. If

you were cutting an opening in the center of a

panel, you would feed the router in a clockwise

direction, so that the edge of the opening would

be cut against the rotation of the bit as de-

scribed, and have a smooth finish. Whenever

you are cutting completely around a workpiece,

it is advisable to cut across the grain first, so any

corner tearout may be smoothed by cutting with

the grain on the second pass.

WORK

CUTTER

Rate of Feed

When routing or doing related work in wood

and plastics, the best finishes will result if the

depth of cut and feed rate are regulated to keep

the motor operating at high speed. Feed the

router at a moderate rate. Soft materials gener-

ally require a faster feed rate than hard materi-

als.

The router may stall if improperly used or

overloaded. Reduce the feed rate to prevent

possible damage to the tool. Do not attempt to

BM 3609929671 1/95

start the tool when the bit is engaged. Always be

sure the collet nut is tightened securely before

use. Always use bits with the shortest cutting

length necessary to produce the desired cut to

minimize router bit run-out and chatter.

To use the templet guides 19 that are listed in

the BOSCH catalog, your router is supplied

with a templet guide adaptor 18, which is fas-

tened to the base with the two countersunk

screws provided. Optional templet guides may

be inserted and held in place along their edges

with the two screws provided with the templet

guide. Some templet guides have holes for

mounting, but these holes are not required for

use with the adaptor plate shown, as it grips the

edge of the templet guide.

Templet guides are used with a number of

accessories which are listed in your BOSCH

catalog. In addition, special templets are easily

prepared for cutting repeated patterns, designs,

inlays, and other applications. A templet pat-

tern may be made of plywood, hardboard, metal

DIRECTION

or even plastic, and the design can be cut with

OF FEED

a router, jigsaw, or other suitable cutting tool.

Patterns must compensate for the distance be-

tween the router bit and the templet guide, as the

final workpiece will differ in size from the

t e m p l e t

pattern by

t h a t

a m o u n t ,

due to the

cutter po-

sition.

Templet Guides

12/7/98, 11:56 AM