Anchor ACCLAIM Snelstarthandleiding

Blader online of download pdf Snelstarthandleiding voor {categorie_naam} Anchor ACCLAIM. Anchor ACCLAIM 2 pagina's.

PAIRING ANCHORLINK WIRELESS MICROPHONES

PAIRING BUTTON

INDICATOR LIGHTS

1. Turn on Mic Receiver (Volume knob clockwise) then hold Pairing button until green light

for Mic 1 flashes, release button.

2. Turn on Mic then press and hold Mute button until Mic red light turns off, release button.

3. Press and hold Mute button again until Mic green light flashes.

4. The Mic is paired when the green light is solid on both the Mic and Mic Receiver.

5. Repeat these steps for Mic 2 on the same Mic Receiver (Mic 1 will stay paired through

this process). If applicable, repeat these steps for Mic 3 and 4 on Mic Receiver 2.

NOTE: You may pair only one microphone at a time. Each Mic Receiver included supports two wireless microphones.

Two Mic Receivers = Four wireless microphones supported. You will only need to pair your microphone once.

UN-PAIR WIRELESS MICROPHONES

1. Start with the speaker On and the Mic Receiver in the Off position (Volume knob turned

counter-clockwise until "click").

2. Press and hold the Pairing button on the Mic Receiver.

3. While holding the Pairing button, turn on the Mic Receiver (Volume knob clockwise).

4. Continue to hold the Pairing button. Lights will appear in the order listed below. Process

takes approximately 25 seconds:

• Mic 2 – Green blinking

• No Link – Red blinking

• Pause

• Mic 1 – Green blinking

• No Link – Red

5. Once the No Link red light is solid, both Mics have been un-paired.

6. Repeat these steps for the 2nd Mic Receiver (if included).

NOTE: This process un-pairs both Mics from a Mic Receiver. The Mics are not needed to un-pair from the Mic Receiver.

ACCLAIM TABLETOP LECTERN STORAGE IN ACL-BASE

VOLUME/POWER KNOB