Anchor COUNCILMAN Snelstarthandleiding - Pagina 2
Blader online of download pdf Snelstarthandleiding voor {categorie_naam} Anchor COUNCILMAN. Anchor COUNCILMAN 2 pagina's.
Pagina afdrukkenWHAT IS THE COUNCILMAN?
The Councilman is a wired conference system that is reliable and easy to use. The main system
components include:
CHM-100 Chairman Base
DEL-100 Delegate Base
GM-18 Gooseneck Microphone
AN-100CM+ Powered Speaker Monitor
Base to base connection is made using a standard microphone cable with a 3-pin XLR connector.
The AN-100CM+ can power up to 11 microphone bases.
BASIC SYSTEM OPERATION
1. Attach a gooseneck microphone into each base.
2. Plug the AN-100CM+/AN-100CMU2+ powered speaker monitor into a power outlet using the AC cord.
3. Daisy chain all the microphone bases and the AN-100CM+/AN-100CMU2+ powered speaker monitor
using 3-pin XLR cables.
4. Set the speaker monitor power switch to on and increase the volume to desired level.
5. Push the microphone base mic on/off buttons one to talk. Press again to turn off. When a microphone is
live, the talk switch will be illuminated.
6. Adjust the microphone close to the mouth.
7. Set volume controls on each base.
NOTE: The Chairman microphone base has the power to mute all delegate microphones. Each microphone
base has an adjustable volume control.
PAIRING ANCHORLINK WIRELESS MICROPHONES
Only applicable for AN-100CMU2+
PAIRING BUTTON
INDICATOR LIGHTS
1. Turn on Mic Receiver (Volume knob clockwise) then hold Pairing button until green light for Mic 1 flashes,
release button.
2. Turn on Mic then press and hold Mute button until Mic red light turns off, release button.
3. Press and hold Mute button again until Mic green light flashes.
4. The Mic is paired when the green light is solid on both the Mic and Mic Receiver.
5. Repeat these steps for Mic 2 on the same Mic Receiver (Mic 1 will stay paired through this process). If
applicable, repeat these steps for Mic 3 and 4 on Mic Receiver 2.
NOTE: You may pair only one microphone at a time. Each Mic Receiver included supports two wireless
microphones. Two Mic Receivers = Four wireless microphones supported. You will only need to pair your
microphone once.
UN-PAIR WIRELESS MICROPHONES
1. Start with the speaker On and the Mic Receiver in the Off position (Volume knob turned counter-
clockwise until "click").
2. Press and hold the Pairing button on the Mic Receiver.
3. While holding Pairing button, turn on the Mic Receiver (Volume knob clockwise).
4. Continue to hold the Pairing button. Lights will appear in the order listed below. Process takes
approximately 25 seconds.
• Mic 2— Green blinking
• No Link —Red blinking
• Pause
• Mic 1 —Green blinking
• No Link — Red
5. Once the No Link red light is solid both Mics have been un-paired.
NOTE: This process un-pairs both Mics from a Mic Receiver. The Mics are not needed to un-pair from the
Mic Receiver.
VOLUME/POWER KNOB