Carlsbro KICKSTART 10 Instructies - Pagina 4

Blader online of download pdf Instructies voor {categorie_naam} Carlsbro KICKSTART 10. Carlsbro KICKSTART 10 4 pagina's. Carlsbro kickstart bass 20: specifications
Ook voor Carlsbro KICKSTART 10: Specificaties (1 pagina's)

Pagina afdrukken

TOP PANEL FEATURES

1 2

4 5 6 7

1. Input Socket: This is a high impedance unbalanced mono jack

socket. Connect your guitar here using a high quality, shielded

instrument lead.

2. Gain Control: When in overdrive mode, this controls the amount of

gain added to your guitar's signal. Adding gain causes harmonic

distortion of the signal, producing a fuller, crunchier sound for use

in rock music.

3. Overdrive Switch: 'Clean' mode is enabled with the switch out.

When pushed in, overdrive mode is enabled.

4. Bass: This is used to control the level of bass or low frequency

sound. Turn clockwise to boost, anti-clockwise to cut.

5. Treble: As with bass control but for treble or high frequency

6. Reverb: Short for 'reverberation.' Adds an echoing character to

the sound to simulate an acoustic environment. Turn clockwise to

increase the amount added to the signal.

Note: In some conditions (very high reverb and volume settings)

the reverb can feedback. If this happens, the reverb level

should be decreased until the feedback dies away.

7. Volume: Sets the overall volume level for the combo. Turn

clockwise to increase volume.

8. Audio In: A 3.5mm line level jack socket for connection of external

audio devices (e.g. mp3 player, CD player), allowing you to play

along to songs/recordings.

9. Phones: 3.5mm line level jack socket provides a mono signal for

stereo headphone attachment.

Note: that this disconnects the speaker, so headphones can be

used for silent practice.

10. Power LED: The LED will illuminate when the unit is turned on.

When the amp is switched off, the LED will slowly go out.

8 9

REAR PANEL FEATURES

1. Mains Switch: This turns the AC mains power to the unit on or

off. Ensure that the AC power socket and plug are easily

accessible during use

NOTE: The unit is not isolated from the mains until the power

cord is removed

2. IEC Input Socket: Connect the supplied IEC mains lead here.

Should the mains fuse need replacing, it is located below the

mains input. Always replace the fuse with the same type and

rating printed on the rear panel of your amp. If the replacement

fuse blows immediately, then contact your local service agent.

DO NOT fit a higher rated fuse. This appliance must be earthed.

Please ensure the supplied AC power lead is connected to a

mains supply socket fitted with a safety earth connection

NOTE: ALWAYS DISCONNECT THE UNIT FROM THE MAINS

SUPPLY BEFORE CHANGING THE FUSE.

STORAGE

When you are not using your amplifier, disconnect it from the mains

supply and store it away from any source of moisture.