Formax FD 90 Gebruikershandleiding - Pagina 10

Blader online of download pdf Gebruikershandleiding voor {categorie_naam} Formax FD 90. Formax FD 90 11 pagina's. Rotary perforators
Ook voor Formax FD 90: Gebruikershandleiding (11 pagina's)

Pagina afdrukken

Removing Perforating and/or Creasing Wheels

To remove the perforating wheels or the creasing wheel, first remove the shaft with the blade guides then remove the

shaft with the perforating wheels.

Remove the shaft by holding the bearing (29) and pulling it over the spring into the terminal position. Then push the whole

shaft back including the bearing, and remove the shaft from the machine as shown below.

Reverse the process to replace the shaft.

Removing Covers

Covers can be removed after paper processing has been finished and fully disconnected from the power supply. Before

resuming work, the covers must be reattached and secured. The covers should be removed only by a trained technician.

NOTE: The covers should be removed only when service interference, belt replacement or feed roller pressure is required.

Separator Pressure Adjustment

The pressure of the separator on the feed tire (30) of the

feeding shaft must be adjusted to accurately feed the paper

from the feeding table (1).

Turn the separator adjustment wheel (31) clockwise to

increase the pressure on the separator. If a thicker sheet

is fed into the feeding table, the pressure of the separator

should be decreased by turning the wheel counterclockwise.