Common Sense RC Lectron Pro Power Mini Gebruiksaanwijzing - Pagina 2

Blader online of download pdf Gebruiksaanwijzing voor {categorie_naam} Common Sense RC Lectron Pro Power Mini. Common Sense RC Lectron Pro Power Mini 2 pagina's. Ac balance charger

Pagina afdrukken

Common Sense RC Lectron Pro Power Mini Gebruiksaanwijzing

8) Charging NiMH Battery

1. Connect the battery's main (red and black) charge lead to the charge port, which is in the front

side of the charger.

2. Select the battery type "NiMH" by pressing the "BATT" button.

3. Select the proper charging current 1A/2A/3A/4A by pressing the "A" button.

4. Press and hold "A" button for 2 seconds to start charging. The charge status LED will glow to

indicate charging is in progress.

5. During the charging process, the capacity indicator LEDs will light up in sequence.

6. When the battery is fully charged, the capacity indicator LEDs will glow constant white.

WARNING:

Always make sure you are charging NiMH batteries in NiMH mode. Charging Lithium

batteries in NiMH mode can lead to fire, personal injury, and property damage

If your LiPo/LiHV battery won't be used for one week or longer, it should be stored at

approximately 50% charged. Storing a lipo battery either fully charged or discharged

will lead to internal damage and dramatically shorten battery life.

1) After the lipo battery has been discharged, begin charging the LiPo/LiHV following

the battery charging Instructions. Observe the charger carefully to watch for battery to

reach storage charge level.

2) Once the 50% LED is on solid and the 75% LED is blinking, the battery will be at an

appropriate storage charge level. At this point, disconnect the AC plug from the wall

outlet, then disconnect the battery from the charger.

3) Store your lipo battery in a fire resistant container such as a Lipo Safe bag.

TROUBLESHOOTING

LED Blinking Pattern

All LEDs ﬂash white ONCE and

Voltage of one cell in the battery pack is too high or too low

stop 2 seconds in cycle

All LEDs ﬂash white TWICE and

Connection error in Balance port

stop 2 seconds in cycle

All LEDs ﬂash white THREE TIMES

Connection error in Main port

and stop 2 seconds in cycle

- 4 -

CHARGER SPECIFICATIONS

AC Input

Battery Type

Cell Count

Charge Current

Cell T erminate Voltage

Circuit Power

Current Drain for Balancing

Dimension

Weight

LIABILITY EXCLUSION

This charger is designed and approved exclusively for use with the types of battery stated in this

Instruction Manual. Common Sense RC accepts no liability of any kind if the charger is used for

any purpose other than that stated. We are unable to ensure that you follow the instructions supplied

with the charger, and we have no control over the methods you employ for using, operating, and

maintaining the device. For this reason, we are obliged to deny all liability for loss, damage, or costs

which are incurred due to the incompetent or incorrect use and operation of our products, or which are

connected with such operation in any way. Unless otherwise prescribed by law, our obligation to pay

compensation, regardless of the legal argument employed, is limited to the invoice value of those

Common Sense RC products which were immediately and directly involved in the event in which the

damage occured

This charger includes a 1-year warranty that will cover the

cost of replacing or repairing the unit in the event of any

manufacturing defects. The warranty does not include any

damage that may arise from improper use

or user negligence. This includes:

Failure to read and follow instructions

Improper use of the product (abusive use, out of spec. etc.)

Overloading, overheating (desoldering, melting, etc.)

Using in inadequate conditions (damage or rust from rain, humidity, etc.)

Error

Improper maintenance (presence of dirt, etc.)

Disassembly or modiﬁcation by the user

Exposure to moisture

Physical damage sustained by dropping, throwing, or smashing the unit

100-240V

LiPo/LiFe/LiHV/NiMH

LiPo/LiFe/LiHV: 2-4S

NiMH: 6-8S

1A/2A/3A/4A ± 10%

LiPo: 4.2V ± 0.02V / LiFe: 3.6V ± 0.02V

LiHV: 4.35V ± 0.02V / NiMH: -△V

50W

300mA

110x70x40mm

191g

- 5 -

CONFORMITY DECLARATION

This appliance can be used by children aged from 14 years and above and persons with reduced physical, sensory or

mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning

use of the appliance in a safe way and understand the hazards involved. Children shall not play with the appliance.

Cleaning and user maintenance shall not be made by children without supervision.

If the power cord is damaged, it must be replaced by the manufacturer, its service agent or similarly qualiﬁed persons

in order to avoid a hazard.

Never leave the charger unattended when it is connected to a wall outlet. If any malfunction is found, STOP

THE PROCESS AT ONCE.

Keep the charger well away from dust, rain, heat, direct sunshine and vibration. Never drop it.

Never charge batteries on wood, cloth, carpet or on any other flammable material.

During charging, the charger must be placed in a well ventilated area.

This charger is designed and built exclusively for RC Batteries. The allowable AC input voltage is

100~240V AC.

This marking indicates that this product should not be disposed with other household wastes throughout the US.

To prevent possible harm to the environment or human health from uncontrolled waste disposal, recycle it

responsibly to promote the sustain able reuse of material resources. To return your used device, please use the

return and collection systems or contact the retailer where the product was purchased. They can take this

product for environmental safe recycling.

The Power Mini satisfies all relevant and mandatory CE directives and FCC Part 15 Subpart B: 2016.

For EC directives:

The product has been tested to meet the following technical standards:

Test Standards

Title

Household and similar electrical appliances –. Safety –.

EN60335-2-29

Part 2-29: Particular requirements for battery chargers.

CE-LVD

EN 60335-1: 2012

Household and similar electrical appliances - Safety -

Part 1: General requirements

+A11: 2014

Electromagnetic compatibility – Requirements for

EN55014-1: 2006+

household appliances, electric tools and similar

A1: 2009+A2: 2011

apparatus – Part 1: Emission

Electromagnetic compatibility – Requirements for

EN55014-2: 1997+

household appliances, electric tools and similar

A1: 2001+A2: 2008

apparatus – Part 2: Immunity Product Family Standard

CE-EMC

Electromagnetic compatibility (EMC) –

Part 3-2: – Limits for harmonic current emissions (equipment

EN61000-3-2: 2014

input current up to and incelding 16 A per phase)

Electromagnetic compatibility (EMC) - Part 3-3: Limitation

EN61000-3-3: 2013

of voltage supply systems for equipment with rated

current ≤16 A.

Title 47 Telecommunication

PART 15 - RADIO FREQUENCY DEVICES

FCC-SDOC

FCC Part 15B

Subpart B - Unintentional Radiators

This symbol means that you must dispose of electrical from the general household waste when it reaches

the end of its useful life. Take your charger to your local waste collection point or recycling centre.

- 6 -

Result

Conform