Formica Intentek Technische handleiding Gebruik en verzorging, garantie en installatiehandleiding - Pagina 9
Blader online of download pdf Technische handleiding Gebruik en verzorging, garantie en installatiehandleiding voor {categorie_naam} Formica Intentek. Formica Intentek 17 pagina's. Wireless charging surface
Pagina afdrukkenINTENTEK
WIRELESS CHARGING SURFACE
™
TECHINCAL GUIDE USE & CARE, WARRANTY, AND INSTALLATON GUIDE
3H) CONFIRM FIT: Test fit of heat sink to the cavity by placing into
the cavity. Heat sink should not rock side-to-side, but sit evenly
in the cavity. Check to confirm the silver contact pads are visible
through the holes in the heat sink.
Heat shink should not
rock from side-to-side
4. PRODUCTION
4A) COMPLETE EDGING AS NEEDED: Table or counter should be
edged as specified.
5. ELECTRONICS INSTALLATION
5A) UNSCREW MODULE: Unscrew electronic module from heat
sink cover. Retain screws for final assembly.
5B) PEEL BLUE COAT: Peel off blue peel coat from the gap pad.
Take care not to pull off the gray gap pad.
5C) ALIGN HEAT SINK: Align the heat sink in the cavity by visually
centering the heat sink holes on all of the silver contact pads.
FTB-0918 | Rev 2 | 6/20
Make sure all contact
pads are visbile
5D) PLACE 1ST SCREW IN HEAT SINK: Press the heat sink down
and place initial screw - check to confirm all contact pads are still
visible through the holes in the heat sink.
5E) SCREW IN HEAT SINK: Place the remaining three screws into
heat sink and tighten. CAUTION: Do not overtighten screws in the
substrate.
5F) CONNECT MULTIPLE CHARGING ZONES AS NEEDED: If
design calls for multiple electronics zones to be connected, follow
instructions now that are found in the box on the next page. If you
are only installing one charge zone, skip to step 5G.
Wiring should be done before electronics module housing is
attached in next step.
Formica Group Technical Guide
| 9