Formula TECH SUSPENSION TJ3 Gebruikershandleiding - Pagina 10

Blader online of download pdf Gebruikershandleiding voor {categorie_naam} Formula TECH SUSPENSION TJ3. Formula TECH SUSPENSION TJ3 14 pagina's. Shock absorber

Pagina afdrukken

7. Replace the spring (20) and the spacer (61) if necessary. The spacer (61) is sold with a laser marking that shows

the spring it needs to be coupled with in order to ensure that the maximum preload is 10 mm. Using a different

spacer could compromise the preload range and the proper function of the spring. As it's possible to see in the

photo, each spacer is coupled with the respective spring:

Refer to the table below:

Spring Code (20)

090821251

090801231

090781211

090761191

090741171

8. Assembly the washer spring (40), the preload spacer (61) and the spring (20);

9. Set the spring preload with the measure recorded in step n°1. Screw the preload ring grub screws with a 2,5 mm

hex key with a tightening torque of 4 Nm;

10. Assembly the rebound knob (87), apply Loctite 242 on the thread of its screw and tighten it with 10 Nm;

11. Reassemble the uniball spacers.

K (N/mm)

Pre-Load Spacer Code (61)

83,6

042032015

78,7

042032030

73,6

042032045

68,7

042032060

63,6

042032075

Spacer Height (mm)

-End of Procedure-

1,5

Each spacer must be

4,5

coupled with the

respective spring

7,5