CommScope AEKT Instructieblad - Pagina 4

Blader online of download pdf Instructieblad voor {categorie_naam} CommScope AEKT. CommScope AEKT 4 pagina's. For commscope s4-90m-r1-v2 antennas

Lift here

Remote Electrical

Tilt Connection

RF Cable Connection

The installation, maintenance, or removal of an antenna

requires qualified, experienced personnel. CommScope

installation instructions are written for such installation

personnel. Antenna systems should be inspected once a

year by qualified personnel to verify proper installation,

maintenance, and condition of equipment.

CommScope disclaims any liability or responsibility for the

results of improper or unsafe installation practices.

It is recommended that transmit power be turned off

when the field installation is performed. Follow all

applicable safety precautions as shown on this page.

www.commscope.com

Visit our website at www.commscope.com or contact your local CommScope representative or BusinessPartner for more information.

All trademarks identified by ® or ™ are registered trademarks or trademarks, respectively, of CommScope, Inc. 639853 B (09/19)

Instruction of lifting points

The AISG connector fitted to the antenna is designed to accept

any AISG compliant cable assembly, commscope recommends

hand tightening AISG mating connector only. Applied torque to

the connector shall not exceed 1.5N*m.

The female RF connectors fitted to the antenna are designed

to fit jumper cables with standard related male RF connector.

Tighten the RF connector coupling according to torque

specification in antenna label, if the RF connectors are

tightened beyond the recommend torque, the RF connection

to the antenna may be damaged.

SAFETY NOTICE

Lift here

Do not install near power lines.

Do not install on a wet or windy

Power lines, telephone lines,

day or when lightning or thunder

and guy wires look the same.

is in the area. Do not use metal

Assume any wire or line can

ladder.

electrocute you.

639853

Wear shoes with rubber soles and

heels. Wear protective clothing

including a long-sleeved shirt and

rubber gloves.

Page 4 of 4