Advanced Keys AK-PSB05 Installatiehandleiding - Pagina 8

Blader online of download pdf Installatiehandleiding voor {categorie_naam} Advanced Keys AK-PSB05. Advanced Keys AK-PSB05 15 pagina's. Push-start ignition system

Pagina afdrukken

TACH IGNITION PROGRAMMING

Follow steps below to program Tach signal for Tach Ignition Mode. This function allows automatic

START (crank) the engine by single tap the push-start button. Prior to programming, check to ensure

Tach input and ignition outputs (ACC, ON and START) with applicable immobilizer bypass device are

connected/programmed. To enter Tach Program Mode, make sure vehicle ignition if OFF and system

is enabled with push-

Push and hold the

button down

Apply brake 5 times

quickly

Hold brake down

at the 5

STEP 8

Release the button

immediately after

STEP 3

Engine will continue to run if Tach signal successfully programmed.

Engine will shutdown (Ignition OFF) if failed to register the Tach signal.

Note:

• You may repeat the above steps anytime to program new tach signal.

• Verify Tach signal if programming failed. Tach input require a 3v-16v and minimum 20Hz signal.

• Refer to Ignition Test and Troubleshooting and FAQ for more troubleshooting information.

time until

Button LED will flash

Green / Amber alternately

to indicate programming

mode is active.

(within 25 seconds)

Push and hold down

button to START the

engine

Release the button

after engine is running

Once engine reaches

idle RPM (within 2-min)

release the brake to

program the tach signal