Anden A100 Handleiding voor installatie en gebruik - Pagina 9

Blader online of download pdf Handleiding voor installatie en gebruik voor {categorie_naam} Anden A100. Anden A100 16 pagina's.

SYSTEM SET-UP & CHECKOUT

Skip set up and proceed to INSTALLER TEST MODE on page 10 unless:

• A Model A77 or other external control is to be installed

• changing the air sampling rate

1. Make sure the wire access cover has been snapped back onto the

on-board control .

2. Plug unit in and turn power switch to ON .

3. The on-board control screen should display OFF .

90-1854

NOTE: If the display backlight is not on, the first button press (any

button) will only turn on the backlight . Press the button a second time

to achieve function .

4. Hold the MODE button on the on-board control for 3 seconds to

enter the Installer Set-up Menu .

5. Navigate through the following screens to set up the dehumidifier

for the installed application .

Use the UP or DOWN buttons to select items and use MODE to

switch to the next set-up option . To exit installer set-up, all options

must be scrolled through using the MODE button .

6. After the installer set up options have been completed, DONE will

blink for 3 seconds and the control will return to the OFF screen .

90-1854

REMOTE CONTROL

EXTERNAL CONTROL

90-1854

If not installing an A77, leave

DISABLED and press MODE to go

to the next screen . .

90-1854

If installing an A77, use the UP or

DOWN button to select ENABLED,

then press MODE to go to the next

screen .

90-1854

If using the dehumidifier on-board

control, leave DISABLED and press

MODE to go to the next screen .

90-1854

If using a Model 8800 series

thermostat or alternate control as

an external control, use the UP or

DOWN button to select ENABLED,

then press MODE to go to the next

screen .

90-1854