Andersen Eagle VeriLock 13722 Gebruikershandleiding - Pagina 9

Blader online of download pdf Gebruikershandleiding voor {categorie_naam} Andersen Eagle VeriLock 13722. Andersen Eagle VeriLock 13722 15 pagina's.

Pagina afdrukken

Battery Replacement Instructions - continued

Gliding Patio Doors

1. Unlock and open the door panel.

2. Locate the battery tray above the keeper on the

door jamb, or on 4-panel doors, the astragal.

3. Using a small needle nose pliers, grip the center of

the battery tray to remove from the sensor cover

plate.

4. Remove the discharged batteries (see battery

disposal information on page 4).

5. Replace the batteries with (2) two fresh CR-1632

lithium coin cell batteries. Take care to properly

position the "+" terminals of both batteries to

correspond with the "+" marking on the battery

tray for proper battery polarity.

6. Insert the battery tray back into the sensor cover

plate. The tray may encounter light resistance

during insertion. Continue until the outside edge

of the battery tray is flush with the plate.

7. Close and lock the door unit.

8. Verify that the sensor is communicating with the

security control panel by unlocking the door and

checking the keypad for the door unlock message

and then opening the door and checking the

keypad for the door open message.

Finishing and General Care

Finishing

Read and follow the care and maintenance

instructions for you E-Series/Eagle windows and

doors available online at EagleWindow.com.

Mask the hardware to make sure that no paint and

finishing products are allowed to come in contact

with the hardware during the finishing processes.

If you need to remove the lock bezel and lock lever

from casement or awning windows, insert a

protective mask over the bezel opening to protect

the sensor.

In lieu of removing double-hung hardware during

the finishing process, simply mask the sash lock

assemblies with painter's tape to protect them and

the sensor. Also mask off the locking

mechanisms on the outside edge of the sash.

9125921 BB

Revised 07/28/14

Gliding Patio Doors

Battery

Tray

Battery

Tray

Small

Needle Nose Pliers

Interior View

Hinged patio door center strike plates can be

easily masked with painter's tape to protect the

center strike plate and sensor. Carefully set any

removed hardware aside.

The gliding patio door keeper and sensor cover

plate is easily masked with painter's tape to

protect all components.

MISE EN GARDE

When applying casing on the strike jamb side of doors,

make sure fasteners are located above and below the strike

or keeper, so as not to damage the security components.

Lors de l'apposition du boîtier sur le montant latéral des

portes, s'assurer que les attaches sont bien placées au-

dessus de la gâche ou du garde afin d'éviter d'endommager

les composants de sécurité.

User's Guide

Sensor

Cover

Plate

Keeper

Door

Jamb