Bosch Nexxt washer Operating Gebruiks-, onderhouds- en installatiehandleiding - Pagina 18
Blader online of download pdf Gebruiks-, onderhouds- en installatiehandleiding voor {categorie_naam} Bosch Nexxt washer Operating. Bosch Nexxt washer Operating 26 pagina's.
Ook voor Bosch Nexxt washer Operating: Gebruiks-, onderhouds- en installatiehandleiding (37 pagina's), Gebruiks-, onderhouds- en installatiehandleiding (27 pagina's)
Pagina afdrukken
Program
selection
For optimum drying results your
dryer offers several program groups
and additional options.
Select the required drying program
from the program table according
to the examples (see page 19).
Automatic programs
There are automatic programs for
different types of textiles.
(Regular/Cotton or permanent
press).
Regular/Cotton
Permanent Press
The program sequence of
automatic programs is controlled
via sensors. The duration of the
program depends on the measured
degree of moisture in the laundry
and on the selected degree of
dryness (e.g. damp dry or extra dry).
18
Time programs
Time programs run for a specific
time (20, 40, 60 minutes).
In the "Air fluff" stage the dryer runs
on ambient air without a heat
supply for 20 minutes.
Options
Delicates
Press the "Delicates" button for
temperature sensitive textiles.
Observe the care information or
symbols on the textiles. The
temperature of the drying process is
reduced, the drying time is
extended.
Signal
Your dryer outputs different signals,
if the "Signal" button is pressed.
Signal
Type
Start
Short tone
Damp dry
Sequence of medium
length tones
End
Sequence of short
tones
Mal operation
Sequence of long tones
Warning of
Sequence of long tones
malfunction
The signal
i
Warning of malfunction" is
active in any case.
Indicator of program
sequence
The dryer uses an electronic
scanning system for all programs
except the time programs .
A moisture sensor continuously
checks the moisture in the laundry.
Drying ends automatically as soon
as the selected degree of dryness
has been reached.
The drum continues to rotate at
specific intervals for one hour to
prevent creasing.
The current degree of drying and
the level reached during the
program sequence is indicated
via indicator lights (drying, damp
dry, regular dry, wrinkle block/
finished).
If the indicator light wrinkle
i
block/finished" illuminates
when the program selector is in
Off-Position - turn off the
circuit breaker and call for
customer service!