Installation
Care and cleaning
Heat exchanger
– Scope of delivery: dryer, installation and instruction manual, basket for woollens
(depending on the model).
The heat exchanger of the dryer is cleaned automatically when drying is in progress, Cln
appears in the display panel. Do not pull the condensation container out during the cleaning
– Check dryer for transport damage.
process.
– The dryer is very heavy. Do not lift without assistance.
– Be careful to avoid sharp edges.
Dryer housing, control panel, air intake
– Do not install in a room which is susceptible to frost. Water may cause damage once it
Wipe with a soft, damp cloth.
starts to freeze.
Do not use harsh cleaning agents or solvents.
– If in doubt, have the appliance connected by a specialist.
Remove detergent and cleaning agent residue immediately.
– Do not lift the dryer by any of the protruding parts (e.g. the door) as they may break off.
Water may occasionally accumulate between the window and the seal. This does not impair
the functions of your dryer in any way.
Setting up the dryer
Remove all accessories
1.
– The appliance plug must always be accessible.
from the drum.
Filter in the condensation tank
The drum must be empty.
– Ensure that the appliance is installed on a clean,
The filter is cleaned automatically when the condensation container is emptied.
level and firm surface.
However, the filter should still be cleaned regularly under running water. This prevents stubborn
– Do not obstruct the air inlet on the front of the
deposits/dirt from building up.
dryer.
Cleaning is only required if the symbol
– Keep the area around the dryer clean.
condensation container has been emptied.
– Level the dryer using the threaded feet.
Use a spirit level.
– Do not remove the threaded feet under any
1. Pull out the condensation container.
circumstances.
Do not install the dryer behind a door or sliding
2. Pull the filter out of its snap-in lock.
door, which could prevent or restrict opening of the
dryer door. This will prevent children from locking
themselves in and putting their lives in danger.
Clean and level
Make sure that the air inlet
remains unobstructed
2.
Mains connection
see safety information
Page 13.
– Connect to an AC earthed socket. If in doubt, have the socket checked by a specialist.
3. Clean the filter under running water or in the dishwasher.
– The mains voltage and the voltage shown on the rating plate (
Page 10) must be the
same.
– The connected load and necessary fuse protection are specified on the rating plate.
Frost protection
Do not operate the dryer if
4. Refit the filter.
there is a danger of frost.
Preparation
5. Insert the condensation tank so that it locks into place.
1. Empty the condensation container
page 4.
2. Select any programme using the programme selector.
Only operate the dryer with the filter inserted.
3. Press the
Start/Stop button
condensation is pumped into the container.
4. Wait 5 minutes and then empty the condensation container again.
Moisture sensor
5. Turn the programme selector to Off.
The dryer is equipped with stainless-steel moisture sensors. These measure how damp the
Transport
laundry is. After long periods of use, a fine layer of limescale can form on the moisture
sensors.
1. Open the door.
– Preparation of dryer
see Frost protection.
2. Clean the moisture sensors using a damp sponge with a rough surface.
– Transport the dryer in a vertical upright position.
– Following transportation, leave the dryer to stand for two hours.
Do not use steel wool or other abrasive materials.
There may be residual water in the dryer.
This can leak out if the dryer is at an angle.
8
Only when the appliance is
Technical data
switched off.
Dimensions (DxWxH)
60 x 60 x 85 cm (height adjustable)
Weight
approximately 53 kg
Max. capacity
7 kg
Condensation container
4.0 l
Connection voltage
220-240 V
Connected load
max. 1000 W
Fuse protection
10 A
Ambient temperature
5 - 35 °C
Product number/
Inside of door
Production number
You can find the rating plate on the back of the dryer.
Consumption rates
These are guide values determined under standard
flashes again in the display panel after the
conditions.
Spin speed in rpm
Drying time**
(residual moisture)
in min.
Cottons 7 kg
Cupboard Dry*
1400 (approx. 50 %)
128
1000 (approx. 60 %)
149
800
(approx. 70 %)
169
Iron Dry*
1400 (approx. 50 %)
92
1000 (approx. 60 %)
113
800
(approx. 70 %)
133
Easy-Care 3.5 kg
Cupboard Dry*
800
(approx. 40 %)
54
600
(approx. 50 %)
68
*Test program according to DIN EN 61121
**The values may differ from the those specified depending on the type of fabric, mixture of
laundry to be dried, residual moisture in the fabric and loading capacity.
Drum interior light (bulb E14, 25 W)
The drum is illuminated after the door is opened or closed, and also after the programme is
started. It goes out automatically. Replacing the bulb
Page 12.
Optional accessories
(order from the after-sales service using the order number)
WTZ
Washer-dryer stack connection set
11310
The dryer can be stacked on top of a suitable washing machine of the same depth and width,
to save space.
The dryer must be secured to the washing machine with this connection set.
WTZ
Same as WTZ 11310, but with pull-out worktop.
11300
Installation underneath the worktop
WTZ
10290
Instead of the appliance covering plate, you must have a metal cover fitted
by a specialist.
9
Normal noises
What to do if ...
If you cannot rectify a fault yourself (e.g. switching off/on), please contact our after-sales
During drying, the compressor and the pump generate some noise which is entirely normal.
service. We will always find an appropriate solution and will avoid unnecessary visits by
engineers. Trust the expertise of the manufacturer and rest assured that the repair will be
carried out by trained service technicians using original spare parts. The contact details of your
local after-sales service can be found in the enclosed after-sales service directory, or by
calling one of these numbers:
– GB 0844 8928979 (Calls from a BT landline will be charged at up to 3 pence per minute.
The compressor in the dryer may
A call set-up fee of up to 6 pence may apply.)
occasionally generate a droning noise.
The volume and pitch of this may vary
– IE 01450 2655
depending on the selected
When contacting the after-sales service, please quote the appliance's product number (E no.)
programmes and the progress of the
and production number (FD) (see the inside of the door).
drying.
Set the programme selector to Off and remove the appliance plug from the socket.
The
does not light up.
The
indicator lamp flash.
Energy
The
consumption**
indicator lamp flash.
in kWh
Dryer does not start.
The compressor in the dryer is ventilated
1.45
from time to time, which creates a whirring
1.68
sound.
Water is leaking out.
1.96
The door opens by itself.
1.11
Creasing.
1.40
1.68
Drying result is not satisfactory
0.55
(laundry feels too damp).
0.69
The automatic cleaning process causes
a clicking noise.
Drying time too long.
The humidity in the room increases
significantly.
Cln appears in the display panel.
Power cut.
The interior light is not working.
The process of pumping the condensation
into the condensation container generates
pumping noises.
Other intermittent noises and
vibrations.
Loud humming noise for several
seconds.
10
11
Safety instructions
Emergency
– Pull the appliance plug out of the socket immediately or disconnect the fuse.
ONLY use the
– in rooms inside the house.
dryer...
– to dry fabrics.
The dryer must
– be used for purposes other than those described above.
NEVER...
– be modified in terms of its technology or properties.
Hazards
– The dryer must not be used by children or persons who have not been
instructed in its use.
– Do not leave children unsupervised near the dryer.
– Keep pets away from the dryer.
– Remove all objects from the pockets of garments.
Pay particular attention to cigarette lighters
Start/Stop indicator lamp
Mains plug plugged in?
Programme selected?
– Do not lean or sit on the door
symbol and
Start/Stop
Empty container for condensation
see Page 4.
– Secure loose cables
Installation
Clean the condensation container filter if necessary
Page 9.
– Do not operate the dryer where there is a risk of frost.
Each time the dryer is transported, you must wait two hours
before operating it.
Mains
– Connect the dryer according to specifications to an AC earthed socket,
connection
otherwise it cannot be guaranteed that the appliance is completely safe.
symbol and
Start/Stop
Rinse the fluff filter under running water
Page 4.
– The cable cross-section must be sufficient.
Start/Stop button selected?
– Only use earth-leakage circuit breakers with the following symbol:
Door closed?
– The appliance plug and socket must be compatible.
Programme set?
– Do not use multiple plugs/connectors and/or extension cables.
Ambient temperature greater than 5 °C?
– Do not touch or hold the appliance plug with wet hands
Make sure the dryer is level.
Risk of electric shock.
Push the door closed until you hear it click into place.
– Never pull the appliance plug out of the socket by its cable.
– Do not damage the mains lead
Laundry load exceeded?
Remove articles of clothing immediately after the end of the
Operation
– Only laundry must be loaded into the drum.
programme, hang up and pull into shape.
Before switching on the dryer - check the contents.
Unsuitable programme selected
Page 7.
– Do not use the dryer if the laundry has been in contact with solvents, oil, wax,
Warm laundry feels damper than it actually is.
grease or paint (e.g. hair setting spray, nail polish remover, stain remover,
The selected programme does not suit the load. Use another
cleaning solvent, etc.)
drying programme or, in addition, select the time programme
– Hazard caused by dust (e.g. coal dust, flour): do not use the dryer
Page 7.
Risk of explosion!
Use fine adjustment for the drying result
Page 1/2.
– Do not put laundry containing foamed material/rubber in the dryer
Fine layer of limescale on the humidity sensors
Clean the humidity sensors
Page 9.
material may be destroyed and the dryer may be damaged due to possible
Programme termination, e.g. tank full, mains power supply
deformation of the foamed material.
failure, door open or maximum drying time reached.
– Switch off the dryer once the programme has ended.
Rinse the fluff filters under running water
Page 4.
– The water from condensation is not drinking water and may be contaminated
Insufficient supply of air
ensure that air can circulate.
with fluff.
Air inlet possibly blocked
Clear inlet
Page 8.
Defect
– Do not use the dryer if it is defective or if you suspect that it is.
Ambient temperature higher than 35 °C
ventilate the room.
Repairs must only be carried out by the after-sales service.
Make sure the room is sufficiently ventilated.
– Do not use a dryer with a faulty mains lead. To prevent risks, a faulty mains
lead must only be replaced by the after-sales service.
Not an error! Automatic cleaning of the heat exchanger.
– Before changing the bulb of the interior light make absolutely sure you have
Do not empty the condensation container.
pulled the appliance plug from the socket
Remove the laundry from the dryer immediately and spread it
out. Heat may escape.
Spare parts
– Only use genuine spare parts and accessories for safety reasons.
Unplug the appliance plug, fold back the cover cap on the inside
Disposal
– Dryer: unplug the appliance plug, then cut the mains lead from the appliance.
above the door (using a Torx 20 screwdriver) and replace the
Dispose of the dryer at an approved public disposal facility.
bulb. Close the cover cap.
– The heat exchanger contains fluorinated greenhouse gas R-407C covered by
Never operate the dryer without a cover cap.
the Kyoto Protocol
dispose of in a proper manner. Capacity: 0.43 kg.
Not an error!
– Packaging: keep all packaging out of reach of babies and children.
Normal noises
Page 11.
Danger of suffocation!
Has the condensation container been properly reinserted?
– All materials are environmentally safe and recyclable. Dispose of in an
Push the condensation tank all the way in.
Not an error! Normal noises
Page 11.
environmentally-responsible manner.
12
Risk of explosion
Risk of tipping.
Tripping hazard.
Risk of electric shock.
Fire/explosion hazard.
elastic
Dryer
Risk of electric shock!
en Instruction manual
13
Pagina afdrukken