Bosch Series 4 Gebruiksaanwijzing - Pagina 26

Pagina afdrukken

Rails

not rub or use any abrasive cleaning materials.

~ "Cleaning" on page 23

Warning – Risk of burns!

The appliance will become very hot on the outside

;

during the cleaning function. Never touch the appliance

door. Allow the appliance to cool down. Keep children

away from the appliance.

Setting the cleaning function

Make sure you follow all the preparation instructions

before setting the cleaning function.

The cleaning function is preset to run for 1 hour. This

cannot be changed.

Use the function selector to set EcoClean

The length of the cycle will appear on the display.

Use the temperature selector to set the

cycle.

The cleaning function will start in a few seconds. The

remaining time will count down on the display.

Ventilate the kitchen while the cleaning function is

running.

An audible signal will sound when the cleaning function

has finished. The time on the display will be zero.

Switch the appliance off by turning the function selector

to the "Off" position.

Delaying the end time

You can delay the end time if required. Before starting,

touch the

button until the "End" symbol is highlighted

on the display. Use the

The appliance will switch to standby after it is started.

Changing and cancelling

The end time can be changed while the appliance is on

standby.

If you would like to cancel the cleaning function, switch

the appliance off by turning the function selector to the

"Off" position.

Once the cleaning function has ended

Once the cooking compartment has cooled down, wipe

down the cooking compartment with a damp cloth if

necessary.

During operation and while the cleaning function

Note:

is active, reddish patches may form on the surfaces.

This is not rust, but food residues. These patches are

not hazardous to your health and do not limit the

cleaning capacity of the self-cleaning surfaces.

cleaning

button to delay the end time.

pRails

W ith good care and cleaning, your appliance will retain

R a i l s

its appearance and remain fully functional for a long

time to come. This will tell you how to remove the

shelves and clean them.

Detaching and refitting the rails

The rails can be removed for cleaning. The oven must

have cooled down.

Detaching the rails

Lift up the front of the rail

and unhook it (figure A).

Then pull the whole rail forward

and remove it (Fig. B).

Clean the rails with cleaning agent and a sponge. For

stubborn deposits of dirt, use a brush.

Refitting the rails

First insert the rail into the rear socket, press it to the

back slightly (figure A),

and then hook it into the front socket (figure B).

The rails only fit on the right or the left side. Ensure that,

as shown in figure B, levels 1 and 2 are below and

levels 3, 4 and 5 are above. The pull-out rails must pull

out forwards.