Advanced Lighting Systems LiveLED 100 Handleiding voor installatie-instructies - Pagina 9
Blader online of download pdf Handleiding voor installatie-instructies voor {categorie_naam} Advanced Lighting Systems LiveLED 100. Advanced Lighting Systems LiveLED 100 10 pagina's.
8.0 Troubleshooting
Symptom:
Unit does not light
One color won't light
Low performance
No DMX response
9.0 Maintenance of Luminaire
Prior to any maintenance or service of the unit, always disconnect power cord and allow unit to
cool for at least five (5) minutes.
Periodic Cleaning:
Clean the LiveLED at least once every 6 months. Dust exterior with a soft cloth. Make certain that
lenses are free of obstructions and debris.
Fuse Replacement
In the event that the fuses need to be replaced, use only 250 volt 5 amp AC type of fuse. Turn the
power OFF; remove the power cord from the power outlet. Locate the fuse holder on the rear of
the fixture. Remove and replace the fuses if needed. Plug in the power cord and the unit is ready
for continued operation.
For additional assistance or questions contact an authorized distributor or dealer for
Advanced Lighting Systems, Inc. or contact the factory at:
Advanced Lighting Systems, Inc.
519 Lincoln Road
Sauk Centre, MN 56378
Tel: 320.352.0088
Fax: 320.352.0089
A
L
S
,
•
dvAnced
ighting
yStemS
LLc
Probable Cause:
No power to unit
Line voltage is <90 VAC
Power supply failure
Driver failure
Damaged driver
LED board short
Dirty Lens
Damaged lens
Damaged sub-optic board
Bad cable connection
DMX driver malfunction
Address issues
519 L
R
•
S
c
incoLn
oAd
Auk
entRe
9
, m
56378
•
320 352 0088
inneSotA
t
Suggested Remedy:
Check power supply & cord
Use @ rated voltage
Contact Authorized Distributor
Contact Authorized Distributor
Contact Authorized Distributor
Contact Authorized Distributor
Clean lens w/ soft dry cloth
Contact Authorized Distributor
Contact Authorized Distributor
Check cables
Contact Authorized Distributor
Check for proper DMX address
•
320 352 0089
•
f
AdvAncedLighting
.
•
:
com
nASdAq
nexS