Dreamline SHCM-2050-00 Installatiehandleiding - Pagina 6

Blader online of download pdf Installatiehandleiding voor {categorie_naam} Dreamline SHCM-2050-00. Dreamline SHCM-2050-00 7 pagina's. Shower column

IV.

Preparation

1. After opening the box, read this introduction carefully, check all the packed parts are complete by

cross checking of all the components. Examine for shipping damage. If the unit has been damaged or

has a finishing defect, please contact your local distributor within 2 business days. Please note that

Bath Authority™ / DreamLine™ will not replace any damaged product or parts free of

charge, ONCE the product has been installed. Your distributor's responsibility for damage in

transit is limited after the shower package has been transferred to the transportation company, so you

may have to contact the transportation company directly to report damage. Contact your distributor

or DreamLine if you have any questions.

2. You should consult your local building codes on questions on installation compliance standards.

Install all of the required plumbing. Your plumber will need to supply with two ½" male threaded

pipes for hot and cold water outlets. Use a competent and licensed (if required by local code)

plumber for all plumbing installation.

3. Please, note that there are some adjustments and drilling might be necessary during the installation

process.

Column Installation

Refer to the technical diagram to choose the proper location for your shower column. You can adjust

the column's vertical position based on the person's height. Measurements given in the technical diagram

are based on the average human height – 68"-70"').

1. Secure shower arm (1) on to the column, do not forget to use O-ring (10) on the shower arm.

2. Place gasket (9) into L-fitting (8).

3. Connect L-fitting (8) with Shower arm water supply fitting (11).

4. Place rubber washer (6) into Shower head (7).

5. Connect the Shower head (7) to the Shower arm (6).

6. Choose the proper location for your column and mark the drill holes (1). Drill the holes on the distance 1

3/4'' from each other.

7. Insert Wall anchors (2) inside the holes.

8. Tighten the screws (3) to the wall with stainless steel washers (12). Leave the screw heads 1/4'' from the

wall.

9. Connect the flexible hot (13) and cold (14) water supply lines to hot (15) and cold (16) water outlets

(supplied by your plumber) accordingly.

10. Hang the Mounting bracket (4) on the screws (3) secured in the wall.

11. Connect the handheld shower head (19) to the hose (17) placing the rubber washer (18) in the fastening

nut and tide it by hands.

Our product may have changes without prior notice

For the latest manual version, please, check online

www.bathauthority.com

Rev 1.1