ComNav 25CI Gebruikershandleiding - Pagina 4

Blader online of download pdf Gebruikershandleiding voor {categorie_naam} ComNav 25CI. ComNav 25CI 11 pagina's. Reversing motor pumpset

You have a three line system if the helm pump is a Capilano Model 250 or 275 (Made by Teleflex),

or there is a Uniflow valve mounted close to the steering cylinder.

You have a two line system if you do not have the above components in your system.

CLEANLINESS must be maintained while making hydraulic connections. Contamination

introduced into the steering system fluid can cause steering components to malfunction,

possibly resulting in a loss of steering.

Before beginning to connect the pump to the steering system, review the following installation

hints:

• Cap or cover the ends of hoses with a

clean rag before pushing them between

bulkheads

• Do not blow copper filings off freshly cut

and reamed copper tube. Wipe the filings off,

instead

• Do not use a tape type thread sealer.

These can shred and enter the steering

system fluid. A teflon based thread sealer,

such as 'LOCTITE P.S.T.'must be used on all

male pipe threads. Do not place thread

sealer on the first two threads.

Opening your hydraulic steering system will allow air to enter the pipes and pumps. This air must

be expelled when the steering system is bled after you refill your system and during the "Setup

Routine" when you can use the Autopilot to expel it.

29010015V1.0(15CI & 25CI Pumps).doc

CAUTION

•Do not place thread sealer on female pipe

threads

•When tightening fittings into the pump

lockvalve, hold the lockvalve, not the motor.

That way, the lockvalve will not twist out of

alignment with the rest of the pump.

•Connection of the pump lines is most easily

made at existing breaks in the steering

system lines. For example: valves, t-joints

and other fittings.