Electrolux WFC25M4BW2 Gebruikershandleiding - Pagina 3
Blader online of download pdf Gebruikershandleiding voor {categorie_naam} Electrolux WFC25M4BW2. Electrolux WFC25M4BW2 22 pagina's.
Pagina afdrukken
First Steps
Unpacking and Leveling - Upright Freezers
Base
Panel
Hinge Screws
Door Connector
Clips
Cabinet Connector
Figure 1
Before starting the freezer, follow these important first steps:
Installation
• Choose a place that is near a grounded electrical outlet.
• For the most efficient operation, the freezer should be located where surround-
ing temperatures will not exceed 110°F (43°C). Temperatures of 32°F (0°C) and
below will NOT affect freezer operation. Additional compressor heaters are not
recommended.
• Allow space around the unit for good air circulation. Leave a 3 inch (75 mm)
space
on all sides of the freezer for adequate circulation.
Installation
Leveling
The freezer must have all bottom corners resting firmly on a solid floor. The floor
must be strong enough to support a fully loaded freezer. Check the cabinet with
a level from side to side. After discarding the crating screws and wood base, level
the cabinet.
To Level Upright Unit:
Once leveled, slightly raise adjustment of front feet so the door closes easily when
opened about halfway.
To Level Chest Unit:
If needed, add metal or wood shims between feet pads and floor.
Cleaning
• Wash any removable parts, the freezer interior, and exterior with mild detergent
and warm water. Wipe dry. DO NOT USE HARSH CLEANERS ON THESE
SURFACES.
Do not use razor blades or other sharp instruments, which can scratch the
•
appliance surface when removing adhesive labels. Any glue left from the tape
can be removed with a mixture of warm water and mild detergent, or touch the
residue with the sticky side of tape already removed. DO NOT REMOVE THE
Base Panel Screws
SERIAL PLATE.
Door Removal
If door must be removed to fit through narrow doorways:
1. Gently lay freezer on its back, on a throw rug or blanket.
2. Remove base panel (some models) by unscrewing two screws from front of
Wire
base panel. (Figure 1)
3. At top of cabinet, remove plastic top hinge cover.
4. Remove screws from top hinge.
5. Remove top hinge from cabinet. Lift door off lower hinge pin.
6. After door is removed, remove the two screws from bottom hinge.
7. To replace door, reverse above order, and securely tighten all screws to prevent
hinge slippage.
(upright models)
3