Bosch GBH 24 VFR Gebruiksaanwijzing - Pagina 10

Blader online of download pdf Gebruiksaanwijzing voor {categorie_naam} Bosch GBH 24 VFR. Bosch GBH 24 VFR 11 pagina's. Bosch power tools hammer drill manual gbh 24 vfr, gbh 24 vre, gbh 24 vfr
Ook voor Bosch GBH 24 VFR: Originele handleiding (15 pagina's), Instructies voor reparatie (11 pagina's)

Pagina afdrukken

Change the SDS-plus

Tool Holder (GBH 24 VFR)

The SDS-plus tool holder can easily be replaced

by the keyless chuck supplied with the machine.

The keyless chuck serves for rapid insertion of

the tools without the SDS-plus (e. g. round shaft

drill, screwdriver bits).

Do not hold the machine by the chuck!

Removal

Danger of injury! Before removing the

chuck, make sure to remove the tools or

bits.

Tightly grip the chuck locking ring 3 and pull

strongly in the direction of the arrow. Remove the

chuck.

Mounting

Using the whole hand, tightly grip the chuck.

Twist it onto the taper shaft of the chuck until it is

clearly heard to latch. The chuck automatically

locks.

Check the locking function by pulling at the

chuck.

Keyless Chuck for Tools with a

Cylindrical Shaft (GBH 24 VFR)

Tools with a cylindrical shaft can be clamped us-

ing the keyless chuck.

The keyless chuck is not suitable for

hammer drilling.

Mounting the Keyless Chuck

Remove the SDS-plus tool holder. Mount the

keyless chuck in the same way as the SDS-plus

tool holder.

17 • 1 619 929 589 • TMS • 08.08.02

Open the Keyless Chuck

(see figure

Loosen chuck by turning the interlock 15 clock-

wise

Open chuck by turning it counter-clockwise.

Clamping the Tool

Insert the tool and manually close chuck while

holding knurled ring 16.

Lock chuck by turning interlock 15 counter-clock-

wise

Set the impact stop switch 5 to "Drill".

Removing the Keyless Chuck

Tightly grip the chuck locking ring 3 and pull it

strongly in the direction of the arrow.

Tool inserts with cylindrical shank can be

clamped with the key type drill chuck (accessory)

and the corresponding adapter (accessory).

Clean and lightly grease the adapter shank.

Insert the assembled chuck with a twisting man-

ner into the tool holder until it latches. The chuck

locks itself. Check the locking by pulling on the

chuck.

The machine is also suitable for occasional

screwdriving applications, however, not for

screwdriving applications with extreme re-

ductions of speed at which the overload

clutch frequently responds.

For screwdriving, the universal bit holder with

SDS-plus shank (accessory) must be used.

– Set the impact stop switch 5 to "Drill".

– Set the direction of rotation to right-hand rota-

– Regulate the speed with the On/Off switch 7.

English - 5

)

AUF

Key Type Drill Chuck for Tool

Inserts with Cylindrical Shank

(GBH 24 VRE)

Set the impact stop switch 5 to "Drill-

ing" (only at a standstill).

Screwdriving (see figure

tion.

)