Electrolux EGS6343 Gebruikershandleiding - Pagina 10

Blader online of download pdf Gebruikershandleiding voor {categorie_naam} Electrolux EGS6343. Electrolux EGS6343 16 pagina's. Electrolux hob

Pagina afdrukken

10 www.electrolux.com

7. INSTALLATION

WARNING!

Refer to "Safety information"

chapter.

WARNING!

The following instructions about

installation, maintenance and ven-

tilation must be carried out by

qualified personnel in compliance

with the regulation in force (UNI-

CIG 7129 - 7131). Make sure that

the kitchen is well ventilated: keep

natural ventilation holes open (at

least 100 cm²) or install a me-

chanical extractor hood.

7.1 Gas Connection

Choose fixed connections or use a flexible

pipe in stainless steel in compliance with

the regulation in force. If you use flexible

metallic pipes, be careful they do not

come in touch with mobile parts or they

are not squeezed. Also be careful when

the hob is put together with an oven.

Make sure that the gas supply

pressure of the appliance obeys

the recommended values.

If the supplied pressure has not the speci-

fied value, it is necessary to assemble a

proper pressure regulator in compliance

with the standard UNI EN 88. For Liquid

Gas (LPG) the use of pressure regulator is

allowed only if they are in compliance with

UNI EN 12864. The adjustable connection

is fixed to the comprehensive ramp by

means of a threaded nut G 1/2". Screw

the parts without force, adjust the con-

nection in the necessary direction and

tighten everything.

End of shaft with nut

Washer (additional washer is only for

Slovenia and Turkey)

Elbow

Rubber pipe holder for liquid gas (only

for Slovenia and Turkey)

Rigid connection:

Carry out connection by using metal rigid

pipes (copper with mechanical end) (UNI-

CIG 7129).

Flexible connection:

Use a flexible pipe in stainless steel (UNI-

CIG 9891) with a maximum length 2 m.

When installation is complete,

make sure that the seal of each

pipe fitting is correct. Use a soapy

solution, not a flame!

7.2 Injectors replacement

Remove the pan supports.

Remove the caps and crowns of the

burner.

With a socket spanner 7 remove the

injectors and replace them with the

ones which are necessary for the type

of gas you use (see table in "Techni-

cal Information" chapter).

Assemble the parts, follow the same

procedure backwards.

Replace the rating plate (it is near the

gas supply pipe) with the one for the

new type of gas supply. You can find