dreo DR-HSH002 Gebruikershandleiding - Pagina 8
Blader online of download pdf Gebruikershandleiding voor {categorie_naam} dreo DR-HSH002. dreo DR-HSH002 13 pagina's. Ptc fan heater
Pagina afdrukken
Temperature Adjustment
When the unit is on, press
/ remote control to adjust the temperature from 41
to 95°F in 1°F increments.
When the setting temperature (T0) is reached,
the heater will stop working and enter standby
mode (with 30-second delay). When the room
temperature is lower than the set one (T0), the
heater will start working again.
Oscillation Button
When the unit is on, press
remote control to start oscillating.
To stop oscillating, press it again.
Auto OFF Timer
When the unit is on, press
remote control to cycle through 00 -> 01 -> ... -> 12
-> 00 -> 01 hour timer.When time is up, the unit will
automatically stop running.
To cancel Timer setting, press and hold
heater for 3 seconds, or adjust the timer setting
to 00, or turn the unit off.
Auto LED Display OFF
If no operation is done within 1 minute when
powered on, the display will turn off automatically
（ Only the power indicator light + working mode
light should be on).
To turn the display back on, press any button to
wake it up.
10
or
on the heater
on the heater /
on the heater /
on the
Other Features
The heater is designed with power off memory
function, the heater will always remember
Memory
your last settings (temperature & working
Function
mode oscillation status) once you turn it on
again.
24-Hour
When the heater has been working for
Auto Shut
24 hours continuously without any other
Off
operation, it will shut off automatically.
When the heater is tipped over, the heater will
shut off automatically with malfunction code
"P4" on LED display and beeps.
Tip-Over
Protection
Place the heater back on a flat, level and
stable surface.Turn it on again.
When the ambient temperature is above 122°F,
the heater will stop heating and the overheat
alarm will be triggered with malfunction code
"FF" on LED display and beeps.
Overheat
Protection
Please unplug it from the power source
and power it on again when the ambient
temperature drops below 122°F.
11