Atlantic Doris mixte Ventilo with Fancombination Gebruikers- en installatiehandleiding - Pagina 11

Blader online of download pdf Gebruikers- en installatiehandleiding voor {categorie_naam} Atlantic Doris mixte Ventilo with Fancombination. Atlantic Doris mixte Ventilo with Fancombination 18 pagina's. Electronic towel-drying heater - electric and combined versions

Pagina afdrukken

The device you have just purchased was submitted to many tests and checks ensuring its quality. We

thank you for your choice and trust.We hope you will be fully satisfied.

A few recommendations:

Read the instructions before installing the device.

Power the device off before intervening on it, and check the power supply voltage.

Store the instructions, even after installing the device.

Characteristics of the device:

Cat B or C

: Device complying with NF standard Electricity Performance for the category indica-

IP24

: Device protected against water projections.

Classe II

: Dual insulation.

1) Location of the device

- This device was designed to be installed in residential

premises. In any other case, please call your distributor.

- Installation must be ensured according to the rules of the

art, and in compliance with the standards currently

enforced in the installation country.

- Locate the device within minimum distances from obsta-

cles.

Do not install the device:

In a draft likely to disturb its regulation

(under centralised mechanical ventilation,

etc...).

Under a fixed mains outlet.

Inside volume 1 in bathrooms.

Inside volume 2 if handling the controls are accessible to

persons using the shower or the bath tub.

2) How to install the device

The installation template is printed on the packaging.

1/ Unfasten the carton's flaps and place it against the wall with the lower flap

folded back and resting flat on he floor. Prick out the four drill holes

though the packaging (without drilling) and then remove the packaging.

2/ Carefully mark the drilling points with a pencil (draw a cross, 2cm wide).

3/ Drill the holes.

4/ Screw the sleeve in place. Fit the screws with the washers provided.

5/ Screw the pins on the on the tubes without locking them. Check they

are correctly positioned by inserting them in the sleeves, with the

appliance.After finding the right position, tighten the screws on each pin.

6/ Place the appliance on the wall, in the sleeves.Tighten all the locking

screws. Fit the caps on the ends of the pins.

(shown on the machine's information label)

ted.

NSTALLING THE DEVICE

Volume

150 mm mini

200 mm mini