Atlantic Olympe Classique Gebruikers- en installatiehandleiding - Pagina 10

Blader online of download pdf Gebruikers- en installatiehandleiding voor {categorie_naam} Atlantic Olympe Classique. Atlantic Olympe Classique 14 pagina's. Programmable electronic towel-drying

Pagina afdrukken

4) Programming

With a pilot wire:

The appliance can be controlled remotely if its pilot wire is connected to an appliance fitted with a pro-

grammer, to a central programming unit or to an energy control system.

Chart indicating the orders the device can receive over its pilot wire

Orders received Current absent

Ref/neutral

oscilloscope

Mode achieved

Heating

temperature

With a separate programmer:

The appliance can also be programmed independently by inserting a programmer in the housing at the rear

of the control box.This programmer will create the ECO and COMFORT modes just as you have defined

them for your appliance.

This device enables holding, heating, and drying your towels.

It also enables heating your bathroom. For optimum heating, please do not obstruct

the air outlets located on the sides of the device.

1) Description of the control panel

2) Setting the CONFORT temperature

It is the temperature desired when the room is occupied.

a) Set the switch to

b) Set knob

, the indicator

c) Wait a few hours for the temperature to stabilise.

If the temperature setting does not suit you, adjust it using the adjusting screw

(to be measured between the pilot wire and the neutral).

CONFORT

setting

SING THE DEVICE

to the ON position, the

lights when the ambient temperature is below that desired.

Negative half-

Full alternance

alternance

230V

-115V

ECO

STANDBY

3°C to 4°C

Standby

below

temperature,

CONFORT

about 7°C

setting

Temperature setting knob

with Hors Gel position

and ability to restrict the

range.

Time adjustment knob TURBO 1/4h, 1/2h, 1h, 2h.

Power On indicator

TURBO indicator

TURBO control

ON/OFF switch

Heating indicator

indicator lights.

Positive half-

alternance

+115V

STOP LOAD

SHEDDING

Instant device

stop. Can also

be used for load

shedding.