Dresser Surepowr Sure 150 Installatiehandleiding - Pagina 2
Blader online of download pdf Installatiehandleiding voor {categorie_naam} Dresser Surepowr Sure 150. Dresser Surepowr Sure 150 16 pagina's. Rcs actuators
Pagina afdrukken
This manual gives instructions for storing, installing,
operating and servicing the RCS Surepowr* Series
Sure 150 electrical mechanical actuator. Refer all
questions not covered in this manual to:
Dresser Natural Gas Solutions
16240 Port Northwest Drive Houston, TX 77041
Tel. 832-590-2306 Fax. 713-849-2879
Be sure to include the model and serial number located
on the nameplate of your Sure 150 actuator in all
communications and parts orders. The nameplate is
located on the bottom portion of the spring housing.
Follow local / regional electrical safety laws and
regulations.
2
WARNING
PPE
Approved Personal Protection
Equipment for the site must
be worn.
Intended of Usage
Make Special Note of the following information
regarding intended use for this equipment.
Consult the following documents for intended
use standards:
a) EN(IEC)60079-14 standard
(Explosive Atmospheres – Part 14: Electrical
Installations Design, Selection and Erection)
b) EN(IEC)60079-17 standard
(Explosive Atmospheres – Part 17: Electrical
Installations Inspection and Maintenance)
c)
Any laws, decrees, standards, procedures
or other documents related to the area
in which the actuator shall be installed
Dresser Natural Gas Solutions (NGS) cannot be held
responsible if these standards are disregarded.
Check the compatibility of the actuator's nameplate
markings with the classification of the installation
area's environment and its ambient and admissible
surface temperatures.
Only qualified, certified and properly trained personnel
should conduct actuator installation and maintenance.
Actuator Range of Application
For use in EU countries, IEC participating countries
and any others that accept ATEX/ IECEx certification
This device is designed to meet CE Machinery
directive 2004/42/EC (EN 12100:2010, EN 14121-1:2007)
and Electromagnetic Compatibility (EMC) Directive
2004/108/EC (EN 61000-6-4: 2007, EN 61000-6-2: 2005).
For use in North American "Class, Division"
Classified Areas:
This device is designed for installation in Class I, Division
1 Groups C and D and Class II, Division 1 Groups E, F and
G rated environments within an operating temperature
range of -40°C to +65°C.