Andrew EASIAX Cable Prep Tool Installatie-instructies - Pagina 2

Blader online of download pdf Installatie-instructies voor {categorie_naam} Andrew EASIAX Cable Prep Tool. Andrew EASIAX Cable Prep Tool 2 pagina's.

Remove about 1" (25 mm) of the jacket from the

cable end by scoring and slicing the jacket.

Position the tool on the cable so that the corrugation

guide is about 1/2" (13 mm) from the cable end.

Pull off the cut conductor. Slit and peel the scored

section of jacket.

Andrew Corporation

10500 West 153rd Street

Orland Park, IL U.S.A. 60462

The installation, maintenance, and removal of antenna

systems requires qualified, experienced personnel.

Andrew installation instructions are written for such

personnel. Antenna systems should be inspected once

a year by qualified personnel to verify proper

installation, maintenance, and condition of equipment.

Andrew disclaims any liability or responsibility for the

results of improper or unsafe installation practices.

Telephone: 708-349-3300

FAX (U.S.A.): 1-800-349-5444

Internet: http://www.andrew.com

Lightly squeeze the tool halves together and rotate

the tool clockwise (as viewed from the cable end)

three or four revolutions to score the outer

conductor. Then, firmly squeeze and rotate the tool until

the cut section falls away. Note: Keep a firm and

constant grip on the tool. Do not release the tool during

rotation because this will result in an uneven cut.

Proceed to the connector installation bulletin.

Notice

Customer Service, 24 hours: U.S.A. • Canada • Mexico: 1-800-255-1479

U.K.: 0800 250055 • Other Europe: +44 1592 782612

Printed in U.S.A.9/00