Electrolux CH 910 Instructieboek - Pagina 15

Blader online of download pdf Instructieboek voor {categorie_naam} Electrolux CH 910. Electrolux CH 910 21 pagina's. Stylish stainless steel chimney hood
Ook voor Electrolux CH 910: Gebruikershandleiding (28 pagina's)

Pagina afdrukken

Fitting the Hood Body

Before starting to ﬁ x the hood body, tighten

the two screws Vr located on the top of the

hood body.

Hook the hood body onto the two screws

item 12a (not supplied).

Fully tighten the screws item 12a.

Using a screw driver and spirit level, adjust

the screws item Vr until the hood body is

level.

Extraction

The cooker hood is more effective when used in the

extraction mode (ducted to the outside).

Venting kits may be purchased through your

retailer or DIY store, and must be ducted to an

outside vent of Ø125mm (5") or Ø150mm (6").

The ducting used must be manufactured from ﬁ re

retardent material conforming to the relevant British

Standard or DIN 4102-B1.

When the cooker hood is ducted to the outside the

charcoal ﬁ lter must be removed.

Recirculation

The cooker hood is supplied speciﬁ ed for use in the

recirculation mode, with the charcoal ﬁ lter ﬁ tted.

In the recirculation mode contaminated air is

passed through the charcoal ﬁ lter to be puriﬁ ed

and recirculated into the kitchen through the grille

outlets on either side of the chimney.

To assemble the recirculation duct, place the

recirculation outlet connection item 15 into the

support item 7.3.

Insert the extension ducts item 14.1 into either

side of the recirculation outlet item 15 ensuring the

connections are vertically and horizontally aligned

with the outlets in the chimney.

Connect the recirculation oulet item 15 to the outlet

on top of the hood body using either a piece of

Ø125mm or Ø150mm ﬂ exible or rigid pipe.

Rigid pipe is strongly recommended and should be

used where possible as this will ensure the best

performance while lowering noise.

INSTALLING THE COOKER HOOD