Bosch PSB 6500 RE Originele handleiding - Pagina 11

Blader online of download pdf Originele handleiding voor {categorie_naam} Bosch PSB 6500 RE. Bosch PSB 6500 RE 16 pagina's.

Pagina afdrukken

OBJ_BUCH-911-002.book Page 23 Monday, September 7, 2009 1:08 PM

Assembly

Before any work on the machine itself, pull

the mains plug.

Dust extraction (PSB 650 RA/

PSB 750 RCA) (see figures A

Dusts from materials such as lead-containing

coatings, some wood types, minerals and

metal can be harmful to one's health. Touch-

ing or breathing-in the dusts can cause aller-

gic reactions and/or lead to respiratory infec-

tions of the user or bystanders.

Certain dusts, such as oak or beech dust, are

considered as carcinogenic, especially in

connection with wood-treatment additives

(chromate, wood preservative). Materials

containing asbestos may only be worked by

specialists.

– Use dust extraction whenever possible.

– Provide for good ventilation of the work-

ing place.

– It is recommended to wear a P2 filter-

class respirator.

Observe the relevant regulations in your

country for the materials to be worked.

Use the dust/chip extraction only when

working concrete, brick and brickwork.

Wood or plastic chips can easily lead to clog-

ging.

WARNING Fire hazard! Do not work metal-

lic materials with the extraction device

mounted. Hot metal chips can ignite parts of

the extraction device.

Bosch Power Tools

To achieve optimum extraction results, please

observe the following notes:

– Pay attention that the extraction device faces

flush against the workpiece or the wall. This

also makes drilling at a right angle easier.

– When using the extraction device, always

–

work with the maximum speed.

– After reaching the desired drilling depth, pull

the drill bit out of the drill hole first and then

switch off the impact drill.

– Use the extraction device only with the filter

element 16 mounted, as otherwise

dust/chips could access the interior of the

power tool and cause damage.

– Check the condition of the filter element 16

regularly. Replace a damaged filter element

immediately.

– The dust protection ring 18 can wear, espe-

cially when working with large drill-bit diam-

eters. Replace the dust protection ring when

worn/damaged.

Mounting the Extraction Device (see figure A)

Guide the extraction device 11 from the front to-

ward the bottom side of the impact drill. Pay at-

tention that the extraction device 11 faces flush

against the casing and that it is locked.

Cleaning the Extraction Device

(see figures B–D)

The dust collector 12 is sufficient for approx.

10 drillings with a drilling diameter of 10 mm.

When the extraction force diminishes or when

the level indicator 13 is full, the dust collector

12 must be emptied. For this, press on the rif-

fled surface of the release button 15 and take

off the dust collector 12.

Empty and clean the dust collector 12. Clean the

filter element 16 by gently striking or tapping

against it.

Check the filter element 16 for damage and re-

place it as required.

Press on the holder of the filter element 16 and

pull it out. Replace the filter element 16 includ-

ing the holder. When placing on the holder

again, make sure that the rubber gasket 17 is in-

serted.

English | 23

2 609 004 159 | (7.9.09)