Andrew James AJ000269 Handmatig - Pagina 7

Blader online of download pdf Handmatig voor {categorie_naam} Andrew James AJ000269. Andrew James AJ000269 12 pagina's. Teppanyaki grill standard, xl and xxl

Using the unit
 Pre-heat the grill for approximately 5
minutes. When the control lamp
goes off the grill is ready to use.
 The cooking time depends on the
type and quantity of food as well as
the degree of cooking. Please base
these times on your own experience.
 Always use the spatulas supplied
with the grill, any wooden spatula or
silicone utensils to turn over the
food that is being cooked to avoid
damaging the non-stick coating on
the grill surface.
 When cooking is finished the food
may be kept warm by turning the
controls to MIN.
Drip Tray
Please note: The pan under the
heating plate must be inserted. This is
where excess fat collects. When grilling
you should check the contents regularly
and empty the pan when necessary.
After Use
To switch the device off, first turn the
temperature regulator to OFF and
remove the plug from the socket. Do
not remove the thermostat from the
device until the device has cooled
down, as the temperature sensor is still
very hot after use.
Cleaning
 Always remove the plug from the
mains socket before cleaning and
wait until the unit has cooled down.
 Do not use any wire brush or other
abrasive cleaning utensils as this
could damage the surface of the grill.
 Under no circumstances should the
device be immersed in water or any
other liquid.
Heating plate
 Please remove any food residues
while they are still warm with a
damp cloth or paper towel.
 Always clean the heating surface of
the grill with a soft sponge and soapy
water, then wipe off with clean
water and dry thoroughly with a soft
cloth.
 After drying the surface of the grill ,
we recommend that you apply a
small amount of cooking oil to the
surface of the grill.
Drip Tray
To clean the drip tray, pull it out from
the grill. Dispose of the contents in a
safe manner and always clean the pan
in soapy water.
Housing
Clean the housing after use with a
slightly damp cloth.